Wonderware SRM-1 User manual

Wonderware Mobile Solutions
10111 Richmond Avenue, Suite 650
Houston, TX 77042
Phone: [phone]
Customer Support: 713-344-2610
Fax: [phone]
General Information: [email protected]
Customer Service: [email protected]
Sales: mobilesolutionssale[email protected]
Training: [e-mail]
SRM-1
User Guide
Part No: 85000011

Revision B Page 1 of 2
Introduction
This document provides important information regarding safety, regulatory compliance, and
operation of the Wonderware SRM-1 USB Portable RFID Module. The Module attaches to a
host computer to provide read/write access to Wonderware ST-1 tags and other tags employing
134 kHz TIRIS MPT technology. For application-specific information refer to the Wonderware
Mobile IntelaTrac User Guide or other documentation appropriate to the software application
being used.
Safety and Regulatory Notices
The following notices are required to ensure safe and proper use of the Module. Please read them
carefully and contact SAT if you have any questions.
This apparatus is suitable for use only in nonhazardous locations.
Caution: Changes or modifications not expressly approved by Wonderware Corporation could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This product has been tested and complies with the specifications for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used according to the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which is found by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment or devices
Connect the equipment to an outlet other than the receiver's
Consult a dealer or an experienced radio/TV technician for assistance
FCC ID: OFZSRM1
This Class [*] digital apparatus complies with Canadian ICES-003.
Revision B Page 2 of 2
Cet appareil numériqué de la classe B est conformé à la norme NMB-003 du Canada.
IC: 6984A-SRM1
Following is a reproduction of the product label:
Operation
The SRM-1 attaches to a host computer via the supplied USB cable. No other connections are
necessary. Use the software provided by Wonderware Mobile Solutions to read and write
Wonderware ST-1 tags and other tags employing 134 kHz TIRIS MPT technology. Place the tag
on top of the SRM-1 within or near the circle indicated by the text “PLACE TAG HERE”.