Woodbridge FREESTANDING BATHTUB Assembly instructions

R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
1
READALLINSTRUCTIONSBEFOREUNPACKINGTHEPRODUCT
2PEOPLEAREREQUIREDTOLIFTANDDURING
ENTIREINSTALLATIONOFTHISPRODUCT
INSTRUCTIONSTHAT,IF IGNOREDCOULD RESULT IN DEATH OR SERIOUSINJURY CAUSEDBYINCORRECT HANDLING
ORINSTALLATIONOF THEPRODUCT. THESEINSTRUCTIONSMUST BEOBSERVEDFOR SAFEINSTALLATION.
This products must be installed by a fully insured and licensed plumber only. Installaon of any our product by anyone other
than fully insured and licensed plumber shall void limited warranty. We recommends that such licensed plumber have experience
in the installaon of products.
Limited warranty is void on any commercial installaon
We are not responsible for local code compliance for this product. Building and plumbing codes may vary from state-to-state in
accordance to your locaon. We are not resonsible for providing any compliance cerficaons.
Under no circumstances we are shall not be liable for any and all incidental damages sustained in connecon with this product
Neither manufacture, nor distributor, nor retailer is responsible for water damage or flood caused due to use of this product.
Under no circumstances We shall not be liable for any and all fees, cost of installaon/reinstallaon/removal, subsequent
damage or transportaon in case of the product defect
INSTALLATION AND CARE GUIDE
PREFERED
EDUCATION
PROVIDER
LISTED
TM
ICC
• 2015UniformPlumbingCode (UPC)
•2018 InternationalPlumbing Code (IPC)
•2018 InternationalResidential Code (IRC)
• CSA B45.5/ IAPMO Z124-2017-Plastic PlumbingFixtures
®
®
®
Compliancewith thefollowing codes& standard:
Customer Service Phone: [phone]. (Monday - Friday 9 AM - 5 PM Pacific Time)
Or Email: [e-mail]
SCC Accredited
CB-P/S
OCPS
Accrédité CCN
ANSI
ACCREDITED
ISO/IEC 17065
Product Certification Body
#1000
20200805 REV. 2
FREESTANDING BATHTUB
www.woodbridgebath.com

R
DG
E
R
WOO
DBRIDGE
R
DG
E
R
WOODBRIDGE
R
DG
E
R
WOODBRIDGE
2
TOOLS REQUIRED FOR INSTALLATION (NOT INCLUDED)
OTHERTOOLSMAYBEREQUIRED
SoCloth
or Blanket
Silicone Tape
Measure
Pencil/Marker Hammer
Safety Glass LevelKnife Caulk Gun Adjustable
Wrench
Channel
Lock Pliers
Inspect the bathtub for any damages. If any damage is found please contact your retailer.
SOFT BLANKET
Carefully, remove the tub from it’s crate/box.
ImportantNote:Bathtub must be carried by a minimum
of 2 adult people in upside down posion only. Do not
carry the bathtub by its panel.
To avoid scratches or damages to the bathtub be sure
to set it on cardboard with soblanket on top of the
cardboard.
Set your bathtub on two 4x4 pieces of lumber so you can have
access from the boom of the bathtub. Put a tray beneath the
bathtub.
Very Important! Before proceeding with installaon, please
check that push pop-up, drain, and integrated overflow are
properly sealed and ghtened.
Push the pop-up into a close posion and fill the bathtub with
cold water above the overflow level to test for overflow leakage
and drain leakage.
Check for any leaks around the drain and pipe. (NOTE: Due to
surface tension, it is normal for a small amount of water to pool
around the drain)
If a leakage occurs please disassemble the drain line or overflow
assemblies and you can apply a plumbing puy/silicone caulk to
fix the leakage.
Once the leakage test was performed you may proceed to the
installaon.
www.woodbridgebath.com

R
DG
E
R
OOD
BRIDGE
R
DG
E
R
WOODBRIDGE
R
DG
E
R
WOODBRIDGE
3
INSTALLATION WITH UNDERFLOOR ACCESS
2. Turn bathtub upside down and set it on a non-abrasive mat, blanket, or cardboard to prevent any scratches
on tub rim.
1. Clean, level and prepare the floor for installaon, Place the tub in the exact installed locaon on the floor
and trace the outline of the bathtub with pencil and mark the drain hole locaon on the floor. Move the
tub away so that the plumbing can be installed.
Moving blanket
TOP
SOFT BLANKET
www.woodbridgebath.com

R
DG
E
R
OD
BRIDGE
R
DG
E
R
WOODBRIDGE
R
DG
E
R
WOODBRIDGE
W
4
1/8”
Tub wall
3. Place a level across the boom of the tub and adjust the tub feet leveler to touch the level. Then raise the
leveler addional 1/8” or 3/16” so that the weight of the tub, water and user are fully supported by the feet
adjuster and not the tub walls.
pop up cover
drain body
rubber drain gasket
tail piece
(provided by installer)
floor
drain pipe
(provided by installer)
trap
(provided by installer)
rubber drain gasket
P-trap
4. Install an 1-1/2" tail piece along with the corresponing flanged washer and 1-1/2" nut to thedrain body.
5. Measure and cut the tail piece to the appropriate length to reach the trap adapter When seng the tub
drain, insert tail piece with 1-1/2" slip joint and rubber washer into the trap adapter and tighten properly.
brass nut
trap adapter
Tub feet leveler
www.woodbridgebath.com

R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
5
6. Apply a generous bead of adhesive or waterproof silicone to the boom of the tub and a bead of tub and le
caulk around the edge of the tub
7. Flip the tub over and carefully set the tub into posion with tail piece assembly to P-trap and connect to the
drain.
8. Fill the tub with water to the overflow and then drain the tub while inspecng the waste and overflow
connecon below the floor for any leaks. Access from below will be necessary for this step.
www.woodbridgebath.com

5
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
6
Note:
If installing on a concrete slab where no underfloor access or cannot move drain.
You may consider following opon.
• Oponal flexible drain hose from plumbing hardware or home improvement store may be used (Woodbridge
will not supply this flexible hose). Connect one end aaches to the bathtub drain and the other end needs to
be aached to the floor drain by using a transion piece.
• Create a bridge from bathtub drain to floor drain by cerfied plumber only because any mis-joint or loosen on
connecon will cause leaks.
9. With the tub now set in place, wipe offany excess tub or le caulking, adhesive where the tub meets the
floor with wet cloth.
10. DO NOT SHOWER or MOVE the tub aer installaon because it will take about 24 hours to get the
silicone sealant to dry.
• Oponal lsland tub drain may also be used.
www.woodbridgebath.com

R
DG
E
R
BRI
DGE
R
DG
E
R
WOODBRIDGE
R
DG
E
R
WOODBRIDGE
WOO
7
2. Turn bathtub upside down and set it on a non-abrasive mat, blanket, or cardboard to prevent any scratches
on tub rim.
1. Clean, level and prepare the floor for installaon, Place the tub in the exact installed locaon on the floor
and trace the outline of the bathtub with pencil and mark the drain hole locaon on the floor. Move the
tub away so that the plumbing can be installed.
Moving blanket
TOP
INSTALLATION ON SLAB FLOOR (NO UNDERFLOOR ACCESS)
SOFT BLANKET
www.woodbridgebath.com

R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
8
1/8”
Tub wall
3. Place a level across the boom of the tub and adjust the tub feet leveler to touch the level. Then raise the
leveler addional 1/8” or 3/16” so that the weight of the tub, water and user are fully supported by the feet
adjuster and not the tub walls.
5. Clean the surrounding of the drain pipe with cloth in preparaon of seng the drain, the area should be dry
and free of any debris. Apply a bead of clear silicon or plumber puy around the drain body and pass it through
the drain hole, also apply plumber puy to the washer and slide it over the boom of the drain body.
4. Measure the actual distance from drain into drain pipe on floor and the drain pipe should extend approximately
1” above the finish floor. Use a drain adapter (not provided) if necessary.
Floor surface
Tub feet leveler
www.woodbridgebath.com

R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
6. Install 1 ½” rubber slip gasket over the drain waste vent.
7. Apply a generous bead of adhesive or waterproof silicone to the boom of the tub and caulk around the
edge of the tub.
8. Flip the tub over and carefully set the tub into posion with tail piece assembly to waste vent and connect
to the drain.
5
9
www.woodbridgebath.com

R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
5
10
9. With the tub now set in place, wipe offany excess tub or le caulking, adhesive where the tub meets
the floor with wet cloth.
10. DO NOT SHOWER or MOVE the tub aer installaon because it will take about 24 hours to get the
silicone to dry.
www.woodbridgebath.com

5
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
11
Care and Cleaning
Retain these installaon instrucons for future reference!
IMPORTANT!
DONOT USE: Abrasivecleanerssuchas:acid,ammonia,bleach, and simmilarsolutions. Useof suchsolutions maycause
corrosion,finishpeeling,and/ordullthe surface.
DONOT USE: Abrasivespongesorcloth.Neverusesteel,wool,orwiredbrushes thatwill permanentlyscratchthesurface.
• Most dirt will wash offwith mild soap and warm water.
• For tough spots, use liquid dish washing soap or non-chlorine bleach.
• Do not use abrasive material such steel wool or scouring pads to clean the acrylic surface.
• Always test the cleaning soluon on a small area before using it on the enre surface.
• Do not allow cleaning to soak on the acrylic surface.
• Rinse thoroughly with water immediately and wipe dry with socloth.
• Use liquid polish compound such as Gel-Gloss Kitchen and Bath Polish(TM) to keep the original shine of acrylic surface.
• Light scratches can be removed with polishing compound for automobiles.
• For deeper scratches use wet sandpaper (1500 grit or higher). Always add water when sanding and lightly sand the area larger
than the scratch in a circular moon to remove the scratches. Repeat unl the scratch is removed. Use socloth and small
amount of polishing compound to restore shine. Repeat as needed unl surface shine is restored.
Repair and Maintenance
Please don't hesitate to contact us if you have any quesons or concerns.
Customer Service Phone: [phone]. (Monday - Friday 9 AM - 5 PM Pacific Time)
Or Email: [e-mail]
The bathtub must be installed and used as described in this manual
Use cauon when entering or exing the bathtub
Do not permit children or persons with infirmies to use the bathtub without supervision of an adult
People using any medicaons or having adverse medical history must consult a physician prior to use of the bathtub
to avoid potenal hyperthermia and possible drowning
Water temperature over 100ºF may cause hyperthermia and/or other health problems. Check water temperature
and adjust it for your personal comfort
Never use bathtub while intoxicated, aer taking meals or any alcoholic beverages. Consuming alcoholic beverages
before or during bathing will cause drowsiness and may result in hyperthermia, loss of consciousness, or even
drowning
If you are pregnant or you feel that you are may be pregnant, consult your doctor before using the bathtub
Never use any electrical devices such as hair dryer, lamp, telephone, tv, radio, or others within 5 feet of the bathtub
Do not overfill the bathtub before enetering. Entering the bathtub when filled will cause overflow and slippery
condions. Use extreme cauon when entering and exing
IMPORTANT SAFETY RULES
ATTENTION! ALWAYS FOLLOW THESE PRECAUTIONS WHEN USING A BATHTUB
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
www.woodbridgebath.com