Woodhaven 6305IC User manual

IftherearetwoclampspindlesincludedwiththeToggleClamp
(6305),removetheshorterspindleandreplaceitwiththe
longerspindle.Forquickerspindleadjustments,replacethetop
nutonthespindlewiththethumbnut(5525).
 Installtwonylonwashers(WN002)oneachofthe1"screws
(5772B),insertthescrewsthruthetwofrontToggleClamp
mountingholes.SlidetheClampPad(6305B)onto
the1"screws(position threaded hole in clamp pad at
rear of toggle clamp)andstartanovalnut(5765B -
raised side first),ontheendofeachscrew.
6305IC
Inboard Clamp
Owners Manual
Please Read Carefully!
BEFORE BEGINNING
 Identifyandverifythatyouhavealltheparts
listed.Readtheinstructionsatleastonce,familiarizing
yourselfwiththepartsbeforebeginning.You'll
needa#3Phillipsscrewdriverforassembly.
 Attachtheclamppadtotherearofthe
ToggleClampusingthe3/8"screw(MP375).
SlidetheToggleClamp/offsetoval
nutsontotheselectedT-slot(s)ofthe
UltraTrack,positionwheredesired
andtightenthetwo1"screws.

Parts List:
Part Description Quantity
6305 Toggle Clamp .........................1
6305ICH Clamp Hardware below:
WN002 Nylon Washer .........................4
5765B Oval Nut .............................2
5772B 1" Screw ..............................2
MP375 3/8" Screw ............................1
5525 Thumb Nut ...........................1
6305B Clamp Pad ...........................1
5772B x2
WN002 x4
5765B x2
MP375
1

15° angle
setting
TheToggleClampmayalsobeangledapproximately
15ºleftorrightbyplacingthe1"Screws(5772B) at
oppositecornersoftheclampblock.
 Anoptional6305R 1" Riser Kitisavailable
whichincreasestheclampcapacityby1"
2
5772B
©Copyright WOODHAVEN INC. 5/5/15
[phone] or WWW.WOODHAVEN.COM