Workspace Travel-X A6P Series User manual

A6P User Instructions

1
A6P series parameter instruction
Electric Control Part:
Input Voltage:100-240Vac 50/60Hz Input current ≤ 3A
Output Voltage:24V DC
Duty cycle:10%MAX 2min on 18min off
Switch power supply,low energy consumption
Manual device can move and long press
Desk frame part:
built-in limit switch
Dynamic load: 120KG
The maximum static load: 140KG
Load speed: 30mm/s
Lift range: 640mm - 1290mm
The length of the adjusting range: 1070mm~1880mm
Other part:
Packing Size: 1270*245*320mm 1 Set
Gross weight: 39.5KG
Safety and warnings
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
Correct Disposal of this product
This marking indicates that this product should not be
disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human
health from uncontrolled waste disposal ,recycle it
responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the
return and collection systems or contact the retailer where
the product was purchased. They can take this product
for environmental safe recycling.

2
Installation Instructions

3
Installation Instructions
Right Side
Left Side

4
Installation Instructions

5
Installation Instructions
5
6
Allign holes of 2 with
pre-drilled holes of TOP
and secure with C screws.
Fix loose cables to TOP
with cable clips E .

6
Installation Instructions
7
8

7
U & D keysP OWN Display Screen Memory keys HOME key
The whole handset surface is a touch panel. If there is no touch within 30 seconds, the screen is locked and
M1/M2/HOME keys are locked correspondingly. You can touch Up or Down keys to unlock screen. When screen
lightened, all keys unlocked and handset enter operation state.
U & D keysP OWN
Touch and hold UP/DOWN key to adjust desk height until you get an optimum height.
Display Screen
Display the height value of the desk.
Memory keys
After setting memory keys, the desk can lift automatically to memory height.
Setting memory:
Touch and hold M1/M2 key for 5 seconds. When a “beep” sound is heard the memory height is
successfully saved. Then light touch M1/M2 to move the desk to memory height automatically.
HOME Key
light touch the HOME key. Desk moves to the optimal height of 72cm automatically.
Safety Function
If the desk encounters resistence while in motion, it will automatically stop and reverse its direction.
Error Codes and Solutions
Error Code
E1
E2
E3
E4
E5
HOT
Fault
Motor has stopped
Over 15mm height
difference between two legs
Loose wire or connection
Communication problem
Overloading problem
Overheating problem
Solution
Power off, wait and restart. If problem persists, then motor is damaged.
Lower desk to lowest position with both legs fully retracted. Power off, wait and
restart. If problem persists then further repair is required.
Power off, check cables and restart. If problem persists cable may be damaged.
Power off, check cables and restart. If problem persists further repair is required.
Lighten load to <180kg. Power off, wait and restart. If problem persists further
repair is required.
Allow motors to cool for 5 minutes before operating again.
Touch and hold HOME
key until the second beep
sound is heard (about 10 s).
Use or keys UP DOWN
to choose , , , , or .A B C D E F
Adjust sensitivity for
downward movement
ATouch
HOME key
1
2
3
4
Most sensitivity
General sensitivity
Least sensitivity
Anti-collision OFF
CM or INCH setting
BTouch
HOME key
2
3
CM
INCH
Height calibration
CTouch
HOME key
Use UP or DOWN key to match
displayed height to measured height
Set height lower limit
DTouch
HOME key
Use UP or DOWN key to desired
lower limit position
Set height upper limit
ETouch
HOME key
Use UP or DOWN key to desired
upper limit position
Adjust sensitivity for
upward movement
ATouch
HOME key
1
2
3
4
Most sensitivity
General sensitivity
Least sensitivity
Anti-collision OFF
Touch M2 to complete
the setting
Touch M2 to return to
normal function