Workspace48 Agile Plus User manual

www.workspace48.com Agile Plus Installation Guide 1

Installation Guide

www.workspace48.com Agile Plus Installation Guide 2

Installation Overview
• To prevent possible scratches or damage,
assemble the Desk upside down on a
soft surface such as a blanket, carpet or
packaging.
• WARNING: Plugging into your electrical
outlet without proper and complete
installation is strictly prohibited!
• Install Time: 20 minutes*
Recommended 2
persons for install

www.workspace48.com Agile Plus Installation Guide 3
A
Slide the cross rails (A) over the preinstalled bolts and slide into place
as indicated by the arrows above. Tighten the screws rmly.
Fasten the foot to the leg column using the M6x18 (1) bolts and insert
the levelling glides (2).

Installation Guide
A
1
2
C
B
D
(A)
(B)
Measure the frame width according to the desired top size from the
chart above. Once the width has been adjusted, tighten the screws
rmly.
(1)
(2)
(A) Frame
Width
For Top
Width
69” 72”
57” 60”
45” 48”
Fasten the support rail (B) to the frame using M8x16 bolts (3).
(3)

www.workspace48.com Agile Plus Installation Guide 4
(9)
(12)
Place the worksurface face down on a clean surface, centering the
frame. Once centered, fasten the support rail (B) to the surface using
the Ø5x17 (4) screws.
Secure the control box to the worksurface using the Ø4.5x16 (9) screws.
Place the support spacers (7) between the center cross rail and the
worksurface. Fasten the rails to the worksurface using the Ø4.5x45 (5)
screws. NOTE: Ensure you use the correct length for each location.

Installation Guide
E
G
F
(9)
(4)
(5)
(7)
DO NOT use Ø5x60 (6) screws
in center position. Screws
will damage top.
(B)
H
Plug the power cable into the control box securing excess cable with a
cable clip (12) and a Ø4.5x16 (9) screw.
(6)

www.workspace48.com Agile Plus Installation Guide 5
Connect both leg motors to the control box.
Connect the handset to the control box.
Tie up any loose cables using the cable ties as shown.

Installation Guide
J
I
K
(13)
3.5x16
L
Fasten the handset to the worksurface using Ø4.5x16 (9). Secure the
cable using provided clips (8).
(9)
(11)

www.workspace48.com Agile Plus Installation Guide 6
Connect the desk to a power outlet. Installation complete!
Level the table by adjusting the levelling feet as needed.

Installation Guide
O
N
M
Rotate the table onto the feet.