World Market 48" BARN WOOD SHELF 542854 User manual

48" BARN WOOD SHELF
SKU - 542854
THANK YOU FOR YOUR PURCHASE. IF YOU HAVE ANY QUESTION PERTAINING
TOASSEMBLY OF THIS PRODUCT, PLEASE CONTACT THE
NEAREST COST PLUS WORLD MARKET STORE. IF YOU ARE NOT NEAR A STORE,
PLEASE CALL OUR CUSTOMER SERVICE CALL CENTER
TOLL FREE AT 877-967-5362 FOR ASSISTACE.

Parts List
Picture Description QtyLabel
A
Page 2
Tool List
Hardware List
H-1
H-2
T-2
T-1
T-3
1
(Not included)
(Not included)
Screws
(L32mm x 4mm)
Wall Plugs
(L42mm x 10mm)
(Drill Bit -10mm)
Allen Key
Screw Driver
H-3 Allen Bolt
(L17mm x 6mm)
Shelf
(Not included)
(Not included)

Turn the shelf (A) in upright position. Locate the stud on the wall. With the help of two people, align assembled shelf (A)
on the wall and mark the location of the hole. Use water leveler to ensure that shelf (A) is in level. Pre-drill holes at
marked location.
Place shelf (A) on a non-marring padded surface. Align bracket end with oval holes over shelf (A) as shown
above in the image. Insert allen bolt (H-3) in the holes and secure with allen key (T-1). Repeat the process to
secure other bracket.
Step-1
Assembly Steps
Page 3
H-3
H-3
H-3
T-1
H-3
A
Leveler
AWall
T2
(not included)

Assembly Steps
Step-2
Assembled view
Page 4
Wall
T-3 H-1
Wall
anchor
Wall
anchor
Wall
anchor
Wall
anchor
A
A
H-2
H-2
T-3
H-2
A
H-2
Insert wall plug (H-1) if you are mounting on a dry wall. Insert screw (H-2) into wall plug (H-1) as shown above in the
drawing. Leave 1/4" of the screw (H-2) out of the wall as shown above in drawing. Align keyhole over screw (H-2) and pull
down shelf (A) until secured. Insert screws (H-2) at lower ends and fully tighten connections with screw driver (T-3).
Note - Shelf is meant to be used with World Market bracket sold separately
Wall
T-3
H-2
Screw
H-2
Screw
Maximum Load - 28 lbs

Care & Maintenance
 Do not put hot items directly on product surface.
 Do not clean product with harsh cleansers or polish.
 Do not expose product in direct sunlight.
 Do not install product near heating or cooling vents.
 Do not write on product without a padded barrier to protect the surface.
 Do not install product outside. For indoor use only.
 Dust and pick-up spills using a clean, non-colored, lint-free cloth.
 Stains may be removed with mild soap solution and damp cloth.
Page 5
 Not for commercial use. For residential use only.