World Market CYRUS 607416 User manual

Page 1
THANK YOU FOR PURCHASE. IF YOU HAVE ANY QUESTIONS
PERTAINING TO THE ASSEMBLY OF THIS FURNITURE PIECE, PLEASE CONTACT
THE NEAREST WORLD MARKET STORE.
IF YOU ARE NOT NEAR A STORE, PLEASE CALL OUR CUSTOMER SERVICE CALL
CENTER TOLL FREE AT 877-967-5362 FOR ASSISTANCE.
CYRUS OVAL RATTAN RIB CONSOLE TABLE
SKU-607416
NOT FOR COMMERCIAL USE.
Assembly Instructions

Page 2
LABEL PICTURE DESCRIPTION QTY
ATable Top 1
B2
Leg
Component List

Page 3
LABEL PICTURE DESCRIPTION QTY
H-1
T-1
Spring Washer
Ø13 x M8
Allen Bolt
M6 x 20 mm
Allen Key
8
1
LABEL PICTURE DESCRIPTION QTY
H-2 8
Hardware List
Tool List

Page 4
Assembly Preparation
Before Beginning :
A
B
H-1
H-2
•Unpack all hardware bags and components to ensure you have all parts-
•Read instructions, cover to cover-
•Have 2 adults on hand for assembly-
•Do not assemble on flooring or carpet-
•Assemble on a clean non-marring surface (packing foam)-
•Save all packaging until finished-
•In case of missing parts, please contact your nearest World Market store
or call our customer service call center at call 1-877-967-5362.
T-1
x 8
x 8
x 1
B

Page 5
Assembly Steps
STEP 1 : Attaching Leg (B) onto Table Top (A)
Using a second person to assist you, lay Table Top (A) upside down onto a padded, non-marring surface. Align
the holes on the first Leg (B) with corresponding holes on Table Top (A) as shown. Secure the Leg (B) using
Allen Bolts (H-2) and Spring Washers (H-1) , stacking the hardware in the order shown. Engage all bolts by
hand first , then fully tighten them using Allen Key (T-1).
Repeat the process above to install the second Leg (B)
T-1
H-2
H-1
A
B
B
NOTE : Levelers on the bottoms of the Leg
Bases may be used for additional leveling
adjustment if needed
STEP 2
Using a second person to assist you, turn the assembly upright as shown.
Congratulations, the Assembly is now complete and the product is ready for use
INSIDE
INSIDE
INSIDE

Page 6
Care & Maintenance

Page 7

Page 8
Long Screw Ø8 x 1 1/2" (1 pcs) Mounting Bracket (1 pcs)
Nylon Strap (1 pcs)
Plastic Screw Anchor (1 pcs)
Anti Tip Kit
Assembly Instructions Enclosed
ANTI TIP KIT
Wall
H-3
H-4 H-5
H-6
Using a second person to assist you, place the unit in the desired final location against a wall mark the drill hole
positioning. Where possible, a wall stud should be used to secure the assembly. Move the assembly away from
the wall slightly and drill a pilot hole in the marked position. Insert the plastic screw anchor ( H-6).
Insert Long Screw (H-2) through Bracket (H-5) and into the corresponding hole in the wall using a phillips head
screwdriver ( not included ). Loop the Nylon Strap (H-3) through the pre-installed D-loop bracket on the console
table assembly and then through the Bracket (H-5) on the wall and cinch the strap closed. Anti-tip kit assembly
is now complete.