World Market Teagan 500630 User manual

THANK YOU FOR PURCHASING OUR QUALITY PRODUCT. IF YOU HAVE ANY
QUESTIONS PERTAINING TO THE ASSEMBLY OF THIS FURNITURE PIECE,
PLEASE CONTACT YOUR NEAREST WORLD MARKET STORE, OR CALL OUR
TOLL FREE NUMBER 877-967-5362 FOR ASSISTANCE.
R
NOT FOR COMMERCIAL USE.
Page 1
Teagan Wood Metal Desk
SKU - 500630
Assembly Instructions

PICTURE QTY
DESCRIPTION
LABEL
8
H-1 Bolt
A1
Table Top
Qty
Picture
T-1 1
Label
Leg
B4Shelf
8
16
H-2 Nut
C
24
H-4 Flat Washer
Description
Wrench
Middle Drawer 1
D1
Drawer 2D2
24
H-3 Lock Washer
6
H-5 Handle Screw
3
H-6 Handle
T-2 1
Phillips Screwdriver
(Not provided)
Ø 8 x Ø 13 x T 2 mm
Ø 8 x 18 mm
Ø 8 x 13 mm
Ø 8 x Ø 19 x T 2 mm
Ø 4 x 27 mm
Size
13 mm
Page 2
H-7 Anti - tip kit 1
PICTURE QTY
DESCRIPTION
LABEL SIZE
Part List
Hardware List
Tool List

In case of missing parts, please contact your nearest World Market
store or our customer service call center 877-967-5362.
Assemble on a clean non-marring surface (packing foam).
Unpack all hardware bags and components to ensure you have all parts.
Read instructions, cover to cover.
Have 2 adults on hand for assembly.
Do not assemble on flooring or carpet.
Save all packaging until finished.
Before Beginning :
Page 3
Assembly Preparation

Step 1
Step 2
Page 4
Assembly Steps
CCC
A
C
H-3
H-1
T-1
8x
H-4
C
CC
C
B
B
B
BC
C
C
C
T-1
H-3
16x
H-2
H-4
A
Place Table Top (A) upside down on a non-marring surface. Position and secure Legs (C) to Table Top (A) with
Flat Washers (H-4), Lock Washers (H-3) and Bolts (H-1) in order shown. Do not fully tighten Bolts.
Position and secure Shelves (B) to Legs (C) with Flat Washers (H-4), Lock Washers (H-3) and Nuts (H-2) in
order shown above by using the Wrench (T-1). Fully tighten Nuts and Bolts from this and previous step.

Mild
Do not put hot items directly on furniture surface.
Do not clean furniture with harsh cleansers or polish.
Do not place furniture in direct sunlight.
Do not place furniture near heating or cooling vents.
Do not write on furniture without a padded barrier to protect the surface.
Do not place furniture outside. For indoor use only.
Not for commercial use. For residential use only.
Dust and pick-up spills using a clean,non-colored, lint-free cloth.
Stains may be removed with mild soap solution and damp cloth.
Care & Maintenance
Cleaner
Page 6

Anti-Tip kit contents Anti-Tip kit installation
WARNING - Children may be injured by tipping furniture and the use of the Anti-Tip Kit is highly
recommended.
This Anti-Tip Kit (H-7) is only a precaution. It is not a substitute for proper adult supervision. Manufacturer or
retailer assumes no liability for improper installation or excess loads placed on screws, brackets, or straps.
When properly installed, this restraint provides protection against unexpected tipping of furniture.
This Anti-Tip Kit MUST be installed into a wall stud using the proper mounting hardware. (Position of Anti-tip
Kit on product depends on wall stud locations).
H-7
Attach to the top back
with screws
(included in the Anti-Tip Kit)
Connect with
plastic straps.
Attach to the wall stud
with screws
(included in the
Anti-Tip Kit)
2x
Anti - Tip Measures
75 mm
Page 7
Children have died from
furniture tipover. To reduce the
risk of furniture tipover:
·ALWAYS install tipover restraint
provided.
·NEVER put a TV on this product.
·NEVER allow children to stand,
climb or hang on drawers, doors,
or shelves.
·NEVER open more than one
drawer at a time.
·Place heaviest items in the
lowest drawers.
This is a permanent label.
Do not remove!
WARNING