World Market LANGLEY 526593 User manual

Rev 01 - April 12, 2017
THANK YOU FOR PURCHASING OUR QUALITY PRODUCT. IF YOU
HAVE ANY QUESTIONS PERTAINING TO THE ASSEMBLY OF THIS
FURNITURE PIECE, PLEASE CONTACT YOUR NEAREST COST PLUS
WORLD MARKET STORE, OR CALL OUR TOLL FREE NUMBER
877-967-5362 FOR ASSISTANCE.
LANGLEY LARGE STORAGE CABINET
SKU # 526593
R
Page 1
Assembly Instructions

Rev 01 - April 12, 2017 Page 2
A : Top Frame - 1 pc
Part List
D1 : Left Door
- 2 pcs
D2 : Right Door
- 2 pcs
E1 :
Back Panel 1
- 2 pcs
F2: Right Shelf
Frame - 1 pc G : Bottom Frame - 1 pc H : Back Lid - 3 pcs
F1: Left Shelf Frame
- 1 pc
I : Center Leg - 3 pcs
B1 : Left Divider
Frame - 1 pc
B2 : Right Divider
Frame - 1 pc
C1 : Left Side Frame
- 1 pc
C2 : Right Side Frame
- 1 pc
D3 : Middle Door
- 1 pc
E2 :
Back Panel 2
- 1 pc
F3: Middle Shelf
Frame - 1 pc
Qty
Description
Picture
Tool List
8
Allen Bolt
Qty
Description
Picture
Label
Hardware List
H-2
Label
Flat Washer
H-3 16
2
Allen Key
T-1
Lock Washer
H-4 16
Shelf Pin
H-5 12
1
T-2
1
T-4 Phillips Screwdriver
(Not provided)
Triangle
8
Allen Bolt
H-1
Anti-Tip Kit
H-6
1
H-7
H-8
H-9
3
3
3
Connector Bolt
Allen Bolt
Flat Washer
Size
Ø6x40 mm
Ø6x55 mm
Ø6xØ10.5xT2 mm
Ø6xØ16xT2 mm
Ø6x10 mm
Ø6x13 mm
Ø10xØ20xT2 mm
1
T-3 Straight Wood Bar
Size
4 mm

Rev 01 - April 12, 2017
Before Beginning :
Page 3
Assembly Preparation
In case of missing parts, please contact your nearest Cost Plus World Market
store or our customer service call center 877-967-5362.
Assemble on a clean non-marring surface (packing foam).
Unpack all hardware bags and components to ensure you have all parts.
Read instructions, cover to cover.
Do not assemble on flooring or carpet.
Save all packaging until finished.
Have 2 adults on hand for assembly.

Rev 01 - April 12, 2017
Assembly Steps
Step 1
Page 4
On a non-marring surface, position and secure Center Legs (I) to Bottom Frame (G) by using
screwing Center Legs (I).
Step 2
On a non-marring surface, position and secure Left Side Frame (C1), Right Side Frame (C2), Left
Divider Frame (B1) and Right Divider Frame (B2) to Bottom Frame (G) with Flat Washers (H-4),
Lock Washers (H-3) and Long Allen Bolts (H-2) by using the Allen Key (T-1).
Then, use the Straight Wood Bar (T-3) as a tool to check the distance between dividers.
Last, use the provided 90° Triangle (T-2) and adjust the corners to make sure the Side Frames
and Dividers are square. Fully tighten Allen Bolts.
C2
C1
B1
G
T-1
H-2
H-3
H-4
8x
Triangle
Triangle
90°
T-2
I
3x
G
I
B2
T-3

Rev 01 - April 12, 2017
Step 3
Page 5
Step 4
Turn assembled unit upright. Insert Back Panels 1 (E1) and Back Panel 2 (E2) to Left, Right Side
Frames (C1 & C2) and Left, Right Divider Frames (B1 & B2).
H
H-6
H-7
H
Detail B
Part Label
Position and secure Back Lids (H) to Back Panels 1 (E1) and Back panel 2 (E2) with Connector
Bolts (H-6), Flat Washers (H-8) and Small Allen Bolts (H-7) by using the Allen Keys (T-1). Do not
over tighten Allen Bolts.
T-1
T-1
1x
H-8
3x
E2
E1
2x
Front
C1
C2
B1
B2
E1
E1
E2

Rev 01 - April 12, 2017 Page 6
Step 6
Front
Step 5
Position and secure Top Frame (A) to Side Frames (C1 & C2) and Divider Frame (B1 & B2)
with Flat Washers (H-4), Lock Washers (H-3) and Short Allen Bolts (H-1) by using the Allen Key
(T-1).
Then, use the Straight Wood Bar (T-3) as a tool to check the distance between dividers.
Last, use the provided 90° Triangle (T-2) and adjust the corners to make sure the Side Board is
square. Fully tighten Allen Bolts.
Front
Insert Shelf Pins (H-5) into the pre-drilled holes on the Side Frames (C1 & C2) and Divider
Frame (B1 & B2). Place Shelf Frames (F1, F2 & F3) onto the Shelf Pins (H-5).
Triangle
90°
Triangle
T-2
H-3
H-4
H-1
T-1
8x
A
G
F1
F2
F3
A

Rev 01 - April 12, 2017 Page 7
Step 7
Position and secure Left Doors (D1), Right Doors (D2) and Middle Door (D3) to Side Frames (C1
& C2) and Divider Frames (B1 & B2) by inserting male hinges into female hinges, which are
pre-installed.
8x
Step 8
Check Cabinet front door alignment. Both doors should be evenly spaced at the top, as shown. If
not, gently push or pull the upper right corner of the misaligned door side and observe the gap
opening or closing. Adjust the corresponding leveler located at the bottom of each Cabinet Foot.
Adjustable Glider
Line up top Edge
of Doors
4x
D1
D2
D1
D2
D3
Front
A

Rev 01 - April 12, 2017
Step 9
H-9
Connect with
plastic straps.
Attach to the top back corner
with screws (included in the Anti-Tip Kit)
Front
Install Anti-Tip Kit (H-9) to the top of both back corners as well as to the wall.
Install them with the Screws and Plastic Straps provided.
Page 8
Step 10
The Langley Large Storage Cabinet is assembled and ready for use.

Rev 01 - April 12, 2017
CARE & MAINTENANCE :
Do not put hot items directly on furniture surface.
Do not clean furniture with harsh cleansers or polish.
Do not place furniture in direct sunlight.
Do not write on furniture without a padded barrier to protect the surface.
Do not place furniture outside. For indoor use only.
Do not place furniture near heating or cooling vents.
Dust and clean-up spills using clean, non-colored, lint-free cloth.
Stains may be removed with mild soap solution and damp cloth.
Clean
Mild
Page 9
CAUTION
Warning - For use with televisions weighing 100lbs (45kg) or less. Use with heavier televisions may
result in instability causing tip over resulting in death or serious injury.
Plasma/LCD-flat panel TV screen of various screen sizes to a maximum TV screen size of 45
inches.
All other support shelves should not be loaded more than 25 lbs.
DO NOT EXCEED RECOMMENDED LOAD. Use with products heavier than the maximum sizes
and weights indicated may result instability causing possible injury.
Do not allow children under 10 year to move unit.
DO NOT REMOVE THIS LABEL
Manufactured for: Cost Plus World Market
SKU#: 526593
Manufactured date: