WPS pro User manual

Have a question? Let us know and we will help.
Email: [e-mail]
Phone: [phone]
WPS pro quick setup guide
WPS pro module has two external antennas –one for radio module and one for
GPS receiver.
Use XLR breakout harness to connect via 2-wire communication or external
trigger input.
Connect red end of the CAT5 cable to WPS pro and yellow to WPS slat(s).
If you are not using WPS high quality CAT5
cables - please remove the clip on the end of
plug where WPS pro is to be connected for
easier connect/disconnect.
Plug the LiPo charger into the Power jack on the panel for easy charging. Once
plugged in, charger indicator light will turn red. Light on the charger will turn
green once battery has been fully charged.
Note: For safety reasons do not leave charging unatended. For long term
storage discharge battery slightly for longetivity of LiPo battery. See User
Manual section 3.1 for more details.

Have a question? Let us know and we will help.
Email: [e-mail]
Phone: [phone]
WPS mote quick setup guide
WPS mote has two external antennas –one for radio module and one for
GPS receiver.
Use 3.5mm breakout harness to connect via 2-wire communication or
external trigger input.
Use mini USB cable for charging. Red LED on WPS mote will turn on once
charging and turn off when fuly charged. Charging at max 1A current.