W4
W13
W12
W13
W12
W4
W3
W3
W3
W3
W3
W3
W2
W2
W1
W1
W1４
W1４
1.5x186mm
carbon tube line1 start line2 start
line1 end
line2 end
19 20
21
23
22
25
24
26 27
28 29
30
31
carbon tube
2X210mm
Screw 6mm+Nut
Screw 6mm+Nut
+ Fastener
（Same installation way
in the symmetry plane.）
T5
T5
L20
L19
W18
L9-1x2
W18
Stick w18 at the ends of 6mm
carbon rod and polishing.
Stick L9-1 at the
end of 12mm
carbon rod
and polishing.
3mm carbon tube
W17
The same installation way in left wing and right wing,
plug the fuselage after finishing.Then hook the pulling wire's spring on the buckle.
Starting point of pulling wire,tie
a knot here for ending point.
Plug the ends of assembled w15 into the
prepared hole of the wing, and fix it.
Connect spring at the finish line
after pulling wire finishing.
2x30mm carbon tube
T1
T2
Connect L26 and L27, use U-shaped steel wire to connect L26 and T2.
Plug the ends of assembled T1 into the prepared hole of L23.
2x30mm
carbon tube
L26x2
W15
W16
32
33
34 Assemble bracket.
B1
B2
B3
B1
B3
B2
T3
Screw 6mm+Nut
+ Fastener
Finished
2pcs stay wires in the rear, according to the numerical order as shown in
below picture to thread wire.The same installation way for the left and right sides.
1 start
2
4
9
10 end
6
2
3
4
5
6
7
spring
spring
