WSI 150 Quick start guide

1
Operational Instructions for WSI Model 150, 300 & 312 Rod BOP
Factory settings for BOPs are male pin
down. BOP rams are marked with
“THIS SIDE UP”stickers. If BOP is
installed female box down rams must
be turned over so that “THIS SIDE UP”
is facing up.
Step 1 of 5: Before operating ram bolt
in either direction you must first loosen
the Packing Gland 1-2 turns. Repeat on
opposite side.
Packing Gland
Ram Bolt

2
Step 2 of 5: Turn ram bolt
counterclockwise, until ram stops
turning to ensure ram bolt is
completely disengaged.
Step 3 of 5: Turn ram bolt clockwise
12-15 times. Repeat on opposite side.
Step 4 of 5: Turn ram bolt clockwise
1-2 times. Repeat on opposite side.
Continue turning 1-2 times alternating
sides until rams are fully engaged.
Step 5 of 5: Once rams are fully
engaged tighten packing gland 1-2
turns. Repeat on opposite side.
*Continue to tighten packing gland, if
necessary by ½ turns to stop leaks.
Step 6 of 6: to fully disengage repeat
steps 1 -2 in order to open rams back
up for operation.