Wyrestorm MXV-0606-H2A User manual

6x6 4K HDR HDBaseT Matrix with 4 Mirrored
HDMI outputs and audio breakout
MXV-0606-H2A Quickstart Guide
Copyright © 2019 WyreStorm Technologies | wyrestorm.com
MXV-0606-H2A Quickstart Guide | 190222
UK: [phone] | ROW: 844.280.WYRE (9973)
[email protected]
1 of 4
WyreStorm recommends reading through this document in its entirety to become familiar with the product’s features prior to starting the
installation process.
Basic Wiring Diagram
IMPORTANT! Installation Requirements
• Visit the product page to download the latest rmware, document version,
additional documentation, and conguration tools.
• Read through the Wiring and Connections section for important wiring
guidelines before creating or choosing premade cables.
• While this product supports CEC, WyreStorm cannot guarantee
compatibility with all forms of CEC communication.
In the Box
1x MXV-0606-H2A Matrix
1 x AC Power Cord with EU pins
1 x AC Power Cord with US pins
1 x AC Power Cord with UK pins
1 x AC Power Cord with AU pins
1x IR Remote
6x IR Emitter
6x IR Receiver
2x Matrix Mounting Brackets with screws
1x Quickstart Guide (this document)
HDMI to display
IR TXIR RX
RXV-35-4K (Receiver)
HDMI to display
Amplifier
IR TXIR RX
HDMI from source
HDMI from source
IR TX
Mirrored HDMI
to display
LAN Cat6a/7
AC Mains
Power
Cat6a/7
Cat6a/7
Blu-ray Player
Satellite Box
RXV-35-4K (Receiver)
Matrix Control Only
IR
Control System
CAB-IR-LINK (Sold Separately)
Wireless Router
MXV-0606-H2A (Matrix)
Receivers
powered by
KEY
HDMI
HDBaseT / Ethernet
Control
Power
Digital Audio

Copyright © 2019 WyreStorm Technologies | wyrestorm.com
MXV-0606-H2A Quickstart Guide | 190222
UK: [phone] | ROW: 844.280.WYRE (9973)
[email protected]
2 of 4
Wiring and Connections
WyreStorm recommends that all wiring for the installation is run and terminated prior to making connections to the switcher. Read through this section in it’s
entirety before running or terminating the wires to ensure proper operation and to avoid damaging equipment.
IMPORTANT! Wiring Guidelines
• The use of patch panels, wall plates, cable extenders, kinks in cables, and
electrical or environmental interference will have an adverse effect on
signal transmission which may limit performance. Steps should be taken
to minimize or remove these factors completely during installation for best
results.
• WyreStorm recommends the use of shielded category cable to minimize
signal noise and interference.
• WyreStorm recommends using pre-terminated HDMI cables due to the
complexity of these connector types. Using pre-terminated cables will
ensure that these connections are accurate and will not interfere with the
performance of the product.
.
IR TX/RX Guidelines
• Using WyreStorm infrared emitters and receivers is the best way to ensure
that most IR coding formats are transmitted and received by the NetworkHD
system. Other 3rd party emitters and receivers can be used; however, these
devices must operate in the same manner as the WyreStorm devices.
• Due to differences in IR across 3rd party control systems their IR ports
should never be connected directly to a NetworkHD system as an
incompatibility may exist. WyreStorm offers a cable that compensates for
voltage differences as well adjusts for differences in the pins used within the
port. Refer to the CAB-IR-LINK product page for more information.
IR TX Port Pinout
Connection for IR TX (transmit) uses a 3.5mm (1/8in) mono plug.
Tip: Anode
Sleeve: Cathode (IR Signal)
IR RX Port Pinout
Connection for IR RX (receive) uses a 3.5mm (1/8in) stereo jack that outputs
+5V DC to power the included IR receiver.
Tip:
Ring: IR Signal
+5V DC
Sleeve: Ground (GND)
RS-232 Wiring
Most control systems and computers are DTE where pin 2 is RX, this can vary
from device to device. Refer to the documentation for the connected device for
pin functionally to ensure that the correct connections can be made.
Matrix RS-232 Port
3rd Party Device
Pin 2 TX (Transmit) ---> To ---> RX (Receive)
Pin 3 RX (Receive) ---> To ---> TX (Transmit)
Pin 5 G (Ground) ---> To ---> G (Ground)
WyreStorm Connector
Note: Pins not shown intable have no connection.

Copyright © 2019 WyreStorm Technologies | wyrestorm.com
MXV-0606-H2A Quickstart Guide | 190222
UK: [phone] | ROW: 844.280.WYRE (9973)
[email protected]
3 of 4
Setup and Conguration
Setup for this matrix including EDID is performed within the Web UI. Refer to Accessing the Web UI for details.
Accessing the Web UI
This matrix is set to a default static IP Address (192.168.11.143). In order to communicate with it initially the PC must be set to a 192.168.11.xxx address with a
subnet of 255.255.0.0. This can be changed back once a static IP is set within a different range.
1. Connect the matrix to the same network as a PC.
2. Open a web browser and enter the IP Address of the matrix.
Default: 192.168.11.143 | Password: admin
Note: The installer password and general password are the same by default. WyreStorm recommends changing the password for installer login to avoid any
unwanted changes being made to the matrix conguration.
Troubleshooting
No or Poor Quality Picture (snow or noisy image)
• Verify that power is being supplied to the transmitter and receiving device
• Verify that all HDMI and HDBaseT connections are not loose and are
functioning properly
• Verify that the HDBaseT cable is properly terminated following EIA568B
standard
• Verify that the output resolution of the source and display is supported by
this matrix and recevier.
• If transmitting 3D or 4K, verify that the HDMI cables used are 3D or 4K rated.
No or Intermittent 3rd party Device Control
• Verify that the IR and RS-232 cables are properly terminated following the
Wiring and Connections section.
Troubleshooting Tips:
• WyreStorm recommends using a cable tester or connecting the cable to
other devices to verify functionality.

Specications
Copyright © 2019 WyreStorm Technologies | wyrestorm.com
MXV-0606-H2A Quickstart Guide | 190222
UK: [phone] | ROW: 844.280.WYRE (9973)
[email protected]
4 of 4
Audio and Video
Inputs 6x HDMI In: 19-pin type A
Outputs
6x HDBT Out: 8-pin RJ-45 Female
6x S/PDIF Out: TOSLINK (Digital Optical)
4x HDMI Out: 19-pin type A
Output Video Encoding HDBaseT Class B
Encoding Data Rate 9.2Gbps
End to End Latency (Max) 10μs (micro seconds)
Audio Formats
Analog: 2ch Analog
S/PDIF: 2ch LPCM | Dolby Digital/DTS up to 5.1ch
HDMI: 2ch LPCM | Multichannel up to Dolby Atmos and DTS-X
Video Resolutions (Max)
Video Resolution HDMI Cat6 Cat6a/7
1920x1080p @60Hz 12bit 15m/49ft 60m/197ft 70m/230ft
1920x1080p @60Hz 16bit 7m/23ft 35m/115ft 40m/131ft
3840x2160p @24Hz 10bit 4:2:0 HDR 3m/10ft 35m/115ft 40m/131ft
3840x2160p @30Hz 8bit 4:4:4 7m/23ft 35m/115ft 35m/115ft
3840x2160p @60Hz 10bit 4:2:0 HDR 3m/10ft 35m/115ft 40m/131ft
4096x2160p @60Hz 8bit 4:2:0 7m/23ft 35m/115ft 40m/131ft
4096x2160p @60Hz 8bit 4:4:4 7m/23ft 35m/115ft 40m/131ft
Note: WyreStorm recommends the use of shielded category cable to minimize signal noise and interference
Supported Standards DCI | RGB | HDR | HDR10 | Dolby Vision up to 30Hz | HLG | BT.2020 | BT.2100
Maximum Pixel Clock HDMI: 600MHz | HDBaseT: 297MHz
Communication and Control
HDMI HDMI 2.0 | HDCP 2.2 | EDID | CEC | DVI/D supported with adapter (not included)
HDBaseT HDMI 2.0 | HDCP 2.2 | EDID | CEC | 1-way PoH | Bidirectional IR
CEC CEC power triggering | Requires CEC compatibility | HDMI outputs only
IR 6x IR RX: 3.5mm (1/8in) TRS Stereo | 6x IR TX: 3.5mm (1/8in) TS Mono | Bidirectional over HDBaseT
RS-232 1x RS-232: 9-pin DB9 Female
Ethernet 1x LAN: 8-pin RJ-45 Female
Power
Power Supply 100~240V AC 50/60Hz
Max Power Consumption 135W
Environmental
Operating Temperature 0 to + 45°C (32 to + 113 °F), 10% to 90%, non-condensing
Storage Temperature -20 to +70°C (-4 to + 158 °F), 10% to 90%, non-condensing
Maximum BTU 461 BTU/hr
Dimensions and Weight
Rack Units/Wall Box 1U
Height 43.5mm/1.72in
Width 440mm/17.33in
Depth 300mm/11.82in
Weight 4.95kg/10.89lbs
Regulatory
Safety and Emission CE | FCC | RoHS | RCM
Warranty Information
WyreStorm Technologies LLC warrants that its products to be free from defects in material and workmanship under normal use for a
period of ve (5) years from the date of purchase. Refer to the Product Warranty page on wyrestorm.com for more details on our limited
product warranty.
Note: WyreStorm reserves the right to change product specication, appearance or dimensions of this product at any time without prior notice.