Xante FilmStar 4 Configuration guide

Instructions!Instructions!
XANTÉ’s FilmStar 4
Desktop Film Making Technology
© 2002-2003 XANTÉ CORPORATION. XANTÉ®is a registered trademark and FilmStar™ is a trademark of XANTÉ CORPORATION. XANTÉ CORPORATION:
Post Office Box 16526, Mobile,AL 36616-0526, USA, Tel. [phone], Fax: [phone], www.xante.com
XANTÉ 1-800-926-8839
Technical Support 1-800-926-8393
1. Pour approximately 8 oz. of the 16 oz.
FilmStar Solution in the bottom of the
FilmStar System.
2. Load film into the FilmStar System,
toner side up. Keep guiding it in until
you feel it stop.
3. Turn the crank away from you slowly, fully
coating the film with solution.
When finished using the FilmStar 4
system, please discard the FilmStar
solution in accordance with federal,
state, and local regulations.
Cleaning Instructions:
For best results, clean the FilmStar 4 base, roller,
and metal guide roller with warm, soapy water
after each use.
FS4 v1 12-9-02