Xerox PHASER 340 User manual

Emptying the waste tray
Approximate time to complete: 3 minutes
The waste tray fits inside the maintenance tray which is located behind the
front cover. You should empty the waste tray anytime you remove the
maintenance tray or when the front panel displays the following message:
Waste Tray Full
Open Front Cover
1. Open the front cover.
Caution Some surfaces inside the printer may be hot. Be careful not to
touch the areas marked with this caution icon:
9101-22

2. When you open the front cover, the following message appears:
Waste Tray Full
Remove Maintenance Tray
3. Grasp the maintenance tray by the front edge and lift up while
sliding it out of the printer.
Note Once the maintenance tray has been partially used, it will leak
drum fluid if tipped. Place the maintenance tray on a flat surface
after removing it from the printer. Contact with the drum fluid
poses no known health risk.
9101-53

4. Lift one corner of the waste tray handle to release it from the
maintenance tray; remove the waste tray from the maintenance
tray.
5. Empty the contents of the waste tray by twisting it. Used ink is
nontoxic; it can be treated as normal office waste.
Each time you remove the waste tray to empty waste ink, be sure
to empty the waste tray completely before replacing it in the
maintenance tray.
Caution Do not load used ink into the printer. Reusing waste ink ruins
the printhead and invalidates the printer warranty.
6. Replace the waste tray in the maintenance tray.
a. Place the side opposite the handle into the maintenance tray
first.
b. Press down firmly in the center of the waste tray to lock it into
place. Make sure the waste tray is fully seated in the
maintenance tray.
9101-39
456
a
b

7. Replace the maintenance tray in the printer.
Note To prevent media jams at the media tray, be sure to push the
maintenance tray into the printer until both sides latch in place.
8. Close the front cover.
Source: 070-9101-03 C4