Xerox Phaser 7300 User manual

Phaser® 7300 Color Printer
Copyright © 2002 Xerox Corporation. All Rights Reserved. 26
Output Trays
You can send output to the following trays:
To change the default output destination on the front panel:
1. With Menus highlighted, press the OK key.
2. Scroll to Printer Setup Menu using the Up Arrow or Down Arrow key.
3. Press the OK key.
4. Scroll to Job Defaults Menu and press the OK key.
5. Select Set Paper Destination and press the OK key.
6. Select either Top Output Tray or Left Side Output Tray and press the OK key.
The output goes to the default tray unless specifically changed in the printer driver.
Note
When you select the Left Side Output Tray as the paper destination and the Left Side Output
Tray is not open, the printer displays an error message on the front panel that the job will not
print until the Left Side Output Tray is opened.
Top Output Tray
■Default output destination.
■Delivers output facedown.
■Can be used for paper up to 18 inches (450 mm)
long.
Left Side Output Tray
■Delivers output faceup.
■Keeps the paper flat so is always used for printing on
envelopes, labels, business cards, and other specialty
media.
■Must be used when you print on paper that is over
18 inches (450 mm) long.
7300-17
2
1

Output Trays
Phaser® 7300 Color Printer 27
Offsetting output
When you send output to the Top Output Tray, you can also select offsetting. Offsetting separates print
jobs or collated sets of a single job by approximately 24 mm (.8 in.) in the output tray.
Note
If you send output to the Left Side Output Tray, the printer does not offset the output.
You must have a hard drive to have the printer offset collated sets.
You can switch job offsetting on or off on the front panel:
1. With Menus highlighted, press the OK key.
2. Scroll to Printer Setup Menu using the Up Arrow or Down Arrow key and press OK.
3. Scroll to Job Defaults Menu and press the OK key.
4. Scroll to Job Offset.
5. Select either On or Off by pressing the OK key.
Note
If you change job offsetting in your printer driver, this overrides the front panel setting for
your print jobs.