XK X380-55 User manual

X380 5.8Ghz FPV Screen Installation (X380-55) Page 1 of 3
Kit Contains:-
Screen holder
Thumb screws and nuts
4.3” FPV screen
USB charger for screen
Antenna
Video transmitter module
amera to video transmitter cable
able ties
Installing the Screen Holder and FPV Screen
1. Place the rear half of the screen holder onto the back of the transmitter,
the location lugs will line up with the holes on the transmitter.
2. Place the front half of the screen holder on the front of the transmitter
in-line with the rear holder and screw in place with the two thumb
screws and nuts provided.
3. Attach the antenna and screen bracket to the FPV Screen.
**Ensure that the 3 switches on the back are set to 1-2-3 in the
off position, (all 3 switches should be set nearest the antenna)**

Page 2 of 3
Distributed by CML Distribution, Saxon House, Saxon Business Park, Hanbury Road, Bromsgrove, Worcestershire, B 0 4AD, England.
V1 03/201
4. Attach the FPV screen to the handset mounted bracket by
connecting the two halves together.
5. Disconnect the power lead that is connected to the X380- and
connect this to Y-power lead. (The Y-power lead is supplied with
the X380- )
6. onnect the other side of the Y-power lead to the X380- power
port.
7. Install the video transmitter in a convenient location using the
foam pad and cable ties provided to keep the wires tidy, then
connect the red connector power lead from the video transmitter
to the Y-power lead red connector.

Page 3 of 3
Distributed by CML Distribution, Saxon House, Saxon Business Park, Hanbury Road, Bromsgrove, Worcestershire, B 0 4AD, England.
V1 03/201
8. onnect the video lead to the X380- camera USB
connector, connect the other end to the black video
transmitter connector. (The USB video lead is supplied
with the FPV kit)
9. Turn on the X380- , amera and then FPV screen, the video will then be transmitting to the
4.3” FPV screen
Changing Transmit and Receive Frequency
If you are using more than one quadcopter at the same location or suffer video interference you can
change the video transmission frequency and the screen receiving frequency.
1. Make sure the amera, FPV screen and X380- are turned off.
2. Select a new receive frequency by adjusting the 3 switches on the back of the FPV screen,
the default is 8 (5725GHz)
H1
H2
H3
H4
H5
H6
H7
H8
ON


1 2 3
ON


1 2 3
ON


1 2 3
ON


1 2 3
ON


1 2 3
ON


1 2 3
ON


1 2 3
ON


1 2 3
5865 GHz
5845 GHz
5825 GHz
5805 GHz
5785 GHz
5765 GHz
5745 GHz
5725 GHz
 = Switch Position
3. Select the matching Transmitter frequency on the Video transmitter by adjusting the
switches to match.
4. Turn on the X380- , amera and then FPV screen, the video will then be transmitting to the
4.3” FPV screen on the new frequency.