7
INSTALL THE MOUNT
1 Put the rubber pad inside the clamp ring;
2 Clamp it on the handlebar of your bike;
3 Use the 2.5mm hex wrench to tighten the screw;
4 Align the tabs on the back of the SPRINT with the bike
mount notches, then press down slightly and turn the
SPRINT clockwise(or anti-clockwise) until it locks into
place.
①
②
③
6
SPRINT use GPS(Global Position System)to measure
speed, calibrate time, record mileage and tracks etc.
After start recording, please make sure to be outdoors
and no shelter above. You should also avoid searching
GPS signal when near high voltage wires and signal
towers.
Track record
FUNCTION DESCRIPTION
Note: It usually takes 30-120 seconds to search GPS signal and
positioning when cold boot. It tooks less than 30 seconds when
warm boot. After successful positioning it will calibrate time
automatically.
SPRINT support all the speed sensor, cadence sensor,
heart rate monitor and power meter that use ANT+ or
Bluetooth 4.0.
Select Menu in the pop-up menu, then select Device
manage to bind and manage your sensor; After switch
bike on the computer, it will automatically select its list of
sensors, supporting up to three bicycles.
Sensor connection
Note: When using speed sensor,you need to set the correct
wheel diameter, in order to get the correct speed.
You can connect SPRINT to computer and get the
standard FIT files, when connected the following icon
will appear on the screen of SPRINT, the device name is
also SPRINT on the computer.
USB connection
USB connection icon
Note: You should end the recording before making a USB connection