Xylem rule 35FA User manual

Float Switch
Instruction Manual

This unit is designed for use with fresh water and
salt water ONLY. Use with any other
hazardous, caustic, or corrosive material
could result in damage to the pump and the
surrounding environment, possible exposure to
hazardous substances and injury.
WARNING

STOP
C

11
2

2
2
2
212 121
1
1
1
21
2
1
2
1
12
12

CE Logo
When this product carries a CE mark, it
conforms to one or more of the following
standards: EN 61000-6-1:2001 EN
61000-6-3:2007
Following the Provisions of the
Electromagnetic Compatibility
Directive 2004/108/EC
ISO 8846 / Electrical Devices Protection
Against Ignition of Surrounding
Flammable Gases
ISO 10133:2000 / Electrical Systems - Extra Low
Voltage D.C. Installations Following
the Provisions of the Recreation Craft
Directive 94/25/EEC
All mounting holes must be sealed with a marine
grade sealant to prevent water intrusion.
SEALANT
Install to ABYC standards

Testing the Float
Switch

+–
+–

A B C D E F G
35A12/24VDC16 Gauge
(1.29mm)
28”
(712mm)
14A (12v)
7A (24v)No 2
37A12/24/32VDC14 Gauge
(1.63mm)
28”
(712mm)
20A(12v)
10A (24v)
6.5A (32v)
No 5
40A12/24/32VDC14 Gauge
(1.63mm)
28”
(712mm)
20A(12v)
10A (24v)
6.5A (32v)
Yes 2
A
Model
B
Voltage
C
Wire Size
D
Wire Length
E
Max. Amps
F
Guard
G
Warranty (years)
110
AC
Always install proper fuse size to prevent damage to
product should a short occur. Failure to install proper
fuse could increase risk of pump malfunction potentially
resulting in personal injury and/or fire hazard.

2"
(5.1cm)
3/4"
(2cm)
5$MAX
30$MAX
OFF
ON

Switch must be mounted equal to or above the
pump base for positive shut-off.
Keep all wire connections above the highest water
level. Wires must be joined with butt connectors and
a marine grade sealant to prevent wire corrosion.
Disconnect power from the system before working
on the unit to avoid personal injury, damage to
the surrounding environment and/or damage to
the unit.
Check out the collection of boat plumbing we offer.