tested
Germany
EMC
R
www.yli.cn We create security
750kg Magnetic Lock
Installation
Drill a hole
Inside:Diameter is 8mm
Outdide:Diameter is16mm
Doorleaf
Drill holes on the
marked positions
Install the Armature Plate
on door leaf
Hollow Matel Door Wooden Door Matel Surface Door
Drill a hole
Inside:Diameter is 8mm
Outdide:Diameter is 12.7mm
Inside:Drill a hole
diameter is 8mm folding
the plastic straight pin
36mm
Steps
Flod the template to 90
Close the door, place the temp-
late on door frame,close to door
leaf.
Template
Door Frame
Door leaf
Template
DoorFrame
Doorleaf
Template
Mark screw positions on door
leaf and door frame.
Setpin
Put the pin into the Armature
Plate.
According to the picture add
the washers on the Armature
Plate.
Plase washers between Armature
plate and door leaf
Allen Key
Use Allen Key to remove the
Mounting plate from lock body
Washers
Wire go through the wire hole,
then screw the mounting plate
on top of the door frame.
Use Allen Key to screw the lock
body on the mounting plate. Close and pull the door to test
holding force,extra washers can
be added toadjust anfle between
door leaf and armature plate.
Confirm the holding force and
tighten the proof screws
Screw door
Wire
Wire
Allen Key
