Yuba SuperMarche Bamboo Box Seat User manual

SuperMarché Bamboo Box Seat
Child Seat Bamboo Box Accessory

2
SuperMarché Box Seat
Child Seat Bamboo Box Accessory
Contents
(1) Seat Board
(1) Super Soft Spot
(1) Seat Belt
(1) Felt Strip
Compatibility
SuperMarché
Note:
Installed Base Board and Bamboo Box required
for assembly (purchase separately)
Recommended:
Two people for assembly
Instructions
1. Cut adhesive backed felt into seven 3.5 by 1.25
cm (1.375 by 0.6in.) rectangles
Figure 1.
3.50
1.50
1.25cm
3.5cm

3
2. Remove paper backing from adhesive
backed felt squares. Place on Back,
and Side Boards between the indexing
cutouts, as shown in Figure 2.
Figure 2.

4
Figure 3.
3. Remove screws and washers from Front
Board and set aside.
4. Lift Front Board and unindex one Side
Board from slots in the Frond Board as
seen below in Figure 3.

5
5. While holding the Front Board and Side
Boards elevated, insert the seat into the
indexing slots in the Side and Back Boards
as seen below in Figure 4.
Figure 4.

6
6. Index the Side Board back into the Front
Board, and lower the assembly until the
Side Boards index into the Base Board.
Figure 5.

7
7. Insert srews, with washers, through the
slots in the Front Boards and into the frame,
as seen in Figure 6. Tighten to 2 N-m, taking
care not to overtighten and damage the
bamboo.
Figure 6.

8
8. Place the Super Soft Spot on the Seat
Board, and thread the straps on the back
pad through the slots in the Back Board as
seen below in Figure 7. Thread the seat pad
straps in a similar fashion through the gap
between the Seat and Side Boards.
Figure 7.

9
9. Fasten the hook and loop sections of the
Super Soft Spot strap underneath the Seat
Board, and fasten the hook and loop section
of the back pad straps over the frame as
seen below in Figure 8.
Figure 8.

10
10. Insert the upper seatbelt buckle horizontally
through the slot in the Back Board as seen
in Figure 9a.
Once fully inserted, rotate the buckle until
it is vertical, and pull the seatbelt from the
inside of the box until the buckle nests in
the cut out in the Back Board as seen in
Figure 9b.
Lift seat pad and repeat step to insert lower
seatbelt buckle into Seat Board.
Figure 9a.
Figure 9b.