Zalip BDW463AM User manual

1
BDW463AM;BDW462AM
WiFi Combo VPN Router
CDW463AM
WiFi Combo Router
BDE460RP-001
WiFi VPN Router
BDW462AM-L
WiFi Combo Security Router
User Manual

2
Copyright
The contents of this publication may not be reproduced in any part or as a whole, stored,
transcribed in an information retrieval system, translated into any language, or transmitted in any
form or by any means, mechanical, magnetic, electronic, optical, photocopying, manual, or
otherwise, without the prior written permission.
Trademarks
All products, company, brand names are trademarks or registered trademarks of their respective
companies. They are used for identification purpose only. Specifications are subject to be changed
without prior notice.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against radio interference in a commercial environment. This equipment can generate, use and
radiate radio frequency energy and, if not installed and used in accordance with the instructions in
this manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause interference, in which case the user, at his own
expense, will be required to take whatever measures are necessary to correct the interference.
CE Declaration of Conformity
This equipment complies with the requirements relating to electromagnetic compatibility, EN
55022/A1 Class B.
Note:
Device is a WLAN operating in 2x2 Spatial Multiplexing/Cyclic Delay Diversity MIMO configurations
and single-stream legacy modes.

3
TABLE OF CONTENTS
COPYRIGHT......................................................................................................................... 2
FCC INTERFERENCE STATEMENT................................................................................... 2
CHAPTER 1. INTRODUCTION ............................................................................................ 4
1.1 PACKAGE LIST.............................................................................................................. 4
1.2 HARDWARE INSTALLATION ....................................................................................... 5
CHAPTER 2. GETTING STARTED...................................................................................... 8
2.1 EASY SETUP BY WINDOWS UTILITY.......................................................................... 8
2.2 EASY SETUP BY CONFIGURING WEB PAGES........................................................16
CHAPTER 3. MAKING CONFIGURATION........................................................................ 21
3.1 BASIC SETTING........................................................................................................... 21
3.2 FORWARDING RULES................................................................................................ 40
3.3 SECURITY SETTING.................................................................................................... 43
3.4 ADVANCED SETTING ................................................................................................. 59
3.5 TOOL BOX....................................................................................................................66
CHAPTER 4. TROUBLESHOOTING................................................................................. 70
APPENDIX A. SPEC SUMMARY TABLE.......................................................................... 74
APPENDIX B. LICENSING INFORMATION...................................................................... 75

4
CHAPTER 1. Introduction
Congratulations on your purchase of this outstanding product: BDW463AM WiFi Combo VPN
Router. This product is specifically designed for Office needs. It provides a complete solution for
Internet surfing, 3G backup, and VPN tunneling. Instructions for installing and configuring this
product can be found in this manual. Before you install and use this product, please read this
manual carefully for fully exploiting the functions of this product.
1.1 Package List
Items Description Contents Quantity
1 WiFi Combo VPN Router 1
2
Power adapter 12V 2A
1
3
CD
1
4 RS232-to-RJ45
1

5
1.2 Hardware Installation
1.2.1 Hardware configuration
1.2.2 LED indicators
LED color Description
Green It is connected to Internet.
WAN Green in flash Data access
Green RJ45 cable is plugged, and Ethernet
connection is established.
LAN Green in flash Data access
Green WiFi is on. WLAN
Green in flash Data access
Amber 3G/3.5G is on.
3G USB Amber in flash Data access
Amber Connection established
3G Express
Card Amber in flash Data access
Amber Serial port connection established
RS232-to-RJ45 Amber in flash Data access
Green in flash Normal mode (The power is on.)
Power Green in fast flash Reset mode

6
1.2.3 Installation Steps
Step 1. Attach the antenna:
Screw the antenna in a clockwise direction to the back
panel of the unit.
DO NOT connect WiFi Combo VPN Router
to power before performing the installation
steps below.
Step 2. Insert the 3G USB to the router:
Plug your USB modem which is with activated SIM
card provided by your 3G service provider.
to the USB interface.
Step 3. Connect with the Ethernet patch cable:
Insert the Ethernet cable into RJ45 Ethernet Port on
the back panel. And then plug the other end of RJ45
into the computer or Laptop computer. The LED of
Internet connection will show green color if the
Ethernet connection is normally connected.
Step 4. Connect the power adapter:
Plug the other end of the power adapter into a wall
outlet.
Step 5. Press the power button

7
Step 6. Start to configure the device:
You can start to configure the device via the Easy
Setup.
(see Easy Setup Utility)

8
CHAPTER 2. Getting Started
2.1 Easy Setup by Windows Utility
Step 1:
Install the Easy Setup
Utility from CD then
follow the steps to
configure it.
Step 2:
Select Language then
click “Next” to continue.
Step 3:
Then click the “Wizard”
to continue.
Or click “advanced” to
run advanced mode for
more detailed setting.
(See User Manual)

9
Step 4:
Click “Next” to continue.
Step 5:
Select time zone. It can
help us to synchronize
the system time with
network time server.

10
Step 6-1:
Configure the schedule
setting for Green
function. You can set
the schedule for turning
on or turning off this
device automatically.
Step 6-2:
Click SMART
Schedule setting for
Green function. The
device would check the
packet flow before the
power is turned off.
For instance, if the
router is on the sleeping
mode, you could surf
the Internet at that time.
Afterwards, if there are
not any packet flows,
the router would be
turned off automatically.

11
Step 7:
Configure your wireless
interface.
Step 8:
Insert SSID, Channel
and Security options,
and then click “Next” to
continue.

12
Step 9:
Auto detect the WAN
service, just click the
[Next] button.
Or you could select the
WAN type by yourself
via select the check box
[Let me select WAN
service by myself] Æ
jump to Step 10.
Step 10:
Select the WAN type by
yourself. You can get
this information by
asking your ISP.

13
Step 11-1：
Select “Auto-Detection”,
and the Utility will try to
detect and configure
the required 3G service
settings automatically.
Click “Next” to continue.
Default PIN Code is
empty, if you have PIN
Code, you must enter it.
For example “0000”. If
no, just Click “Next” to
continue.
Step 11-2：
Or you can select
“Manual” and manually
fill in the required 3G
service settings
provided by your ISP.
Click “Next” to continue.

14
Step 12：
The WiFi Combo VPN
Router is rebooted to
make your entire
configuration take
effect.
Step 13：
Click “Next” to test the
Internet connection.

15
Step 14：
Click “Next” to test
WAN Networking
service or you can
ignore test.
Step 15：
Congratulations!
Setup is completed.
Now you have already
connected to Internet
successfully.

16
2.2 Easy Setup by Configuring Web Pages
You can also browse UI of the web to configure the device.
Browse to Activate the Setup Wizard
Type in the IP Address
(http://192.168.123.254)
Type the default
password ‘admin’ in the
System Password and
then click ‘login’ button.
Select “Wizard” for basic
settings in simple way.
Press “Next” to start the
Setup Wizard.

17
Configure with the Setup Wizard
Step 1:
Setup login password.
Enter your system
password.
Step 2:
Select Time Zone.
Step 3:
Setup Wan Type.

18
Step 4:
Select the WAN type you
would like to use.
If you select “3G Mobile
Service, please jump to
step 5-1. However, if you
click “Fixed Network
Service, please jump to
step 5-2.
Step 5-1:
Set up 3G Dial-up profile.
Step 5-2:
Select WAN type by
yourself. Afterwards,
please fill in necessary
information.

19
Step 6:
Set up your Wireless
Settings.
Type your network ID in
the blank of SSID.
Step 7:
You could choose
whether to configure
Sleep Mode. If you would
like to trigger the sleep
mode, please click “YES”.
If not, please click “NO”
and jump to step 8.
Step 8
Configure the schedule
setting for Green function.
You can set the schedule
for turning on or turning
off this device
automatically.
As for the Smart
Schedule, the device
would check the packet
flow before the power is
turned off.
For instance, if the router
is on the sleeping mode,
you could surf the Internet
at that time. Afterwards, if
there are not any packet
flows, the router would be
turned off automatically.

20
Step 9:
Confirm the information
you set up in User
Interface. If it is correct,
please click ‘Apply
settings’.
Step 10:
Click Finish to complete it.
Step 11:
The system is restarting
to make sure your
configuration take effect.