Zanussi ZFT919Y User manual

GETTING
STARTED?
EASY.
User Manual
ZFT919Y
EN User Manual
Cooker Hood

VISIT OUR WEBSITE TO:
Get usage advice, brochures, trouble shooter, service and repair information:
www.zanussi.com/support
SAFETY INFORMATION AND INSTALLATION
WARNING! Refer to the separate
Installation Instructions booklet for
Safety Information and Installation.
Read carefully the Safety chapters
before any use or maintenance of the
appliance.
PRODUCT DESCRIPTION
CONTROL PANEL OVERVIEW
1 2 3 4 5 6 7 8 9
1On / Off
2First motor speed
3Second motor speed
4Third motor speed
5Maximum motor speed
6Breeze function
7Filter reminder
8Hob to Hood function
9Lamp
DAILY USE
USING THE HOOD
Check the recommended speed according to the
table below.
While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones
or burners, gentle frying.
While boiling and frying big quantities of food without a lid,
cooking on multiple cooking zones or burners.
2

While boiling and frying big quantities of food without a lid,
big humidity.
Refreshes the air in kitchen after cooking at a very low noise
level. It can be activated and de-activated by touching the
symbol. The function turns off automatically after 60 mi-
nutes. Use after cooking only.
It is recommended to leave the hood
operating for approximately 15 minutes
after cooking.
The control Panel is a sensor field.
Touch the symbols for 1 second to
activate the functions.
To operate the hood:
1. Turn on the appliance by pressing the
symbol.
You can now activate the functions.
2. To activate the function touch the symbol.
3. If needed, touch the light symbol to
illuminate the cooking surface.
To turn off the appliance press the symbol
again.
HOB TO HOOD FUNCTION
It is an automatic function which connects the hob
with a hood. Both the hob and the hood have an
infrared signal communicator. Speed of the fan is
defined automatically on basis of mode setting and
temperature of the hottest cookware on the hob.
You can also operate the fan using the hob
manually. The function can be activated from panel
of the hob.
For more information how to use the
function refer to the hob user manual.
ACTIVATING MAXIMUM MOTOR SPEED
When you press the button , the Maximum
Motor Speed starts to operate for 8 minutes. After
that time, the appliance returns to its previous
speed settings.
When the function is turned on,
additional touch on the button
does not have any effects.
ACTIVATING AND DEACTIVATING THE FILTER
NOTIFICATION
Filter alarm reminds to change or clean the charcoal
filter and clean the grease filter. The filter indicator
is turned on (white) for 30 seconds if the
grease filter must be cleaned. The filter indicator
flashes (white) for 30 seconds if the charcoal filter
must be replaced or cleaned.
Refer to filter alarm in care and
cleaning chapter.
1. Switch on the control panel.
2. Make sure that the icons are turned off.
3. To activate or deactivate the charcoal filter
notification touch for 3 seconds.
If the charcoal filter notification is
activated, the filter icon flashes
(white) five times.
If the charcoal filter notification is
deactivated, the filter icon flashes
(white) three times.
CARE AND CLEANING
CLEANING THE GREASE FILTER
Each filter must be cleaned at least once a month.
Filters are mounted with the use of clips and pins
on the opposite side.
To clean the filter:
1. Press the handle of the mounting clip on the
filter panel underneath the hood (1).
3

1
2
2. Slightly tilt the front of the filter downwards (2),
then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first two
steps in reverse order.
Repeat the steps for all filters if applicable.
REPLACING THE CHARCOAL FILTER
WARNING! The charcoal filter is non-
washable!
The time of saturation of the charcoal filter varies
depending on the type of cooking and the regularity
of cleaning the grease filter.
To replace the filter:
1. Remove the grease filters from the appliance.
Refer to "Cleaning the grease filter" in this chapter.
2. press the tab (1) and slightly tilt the front of the
filter.
11
3. To install a new filter, perform the same steps in
reverse order.
In any case, it is necessary to replace the filters at
least every four months.
FILTER ALARM
Refer to activating and deactivating
the filter alarm in daily use chapter.
Refer to cleaning the grease filter in
this chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter (depends
on filter type).
To reset the alarm:
Touch the for 3 seconds.
REPLACING THE LAMP
This appliance is supplied with a LED lamp and
separate control gear (LED driver). These parts can
be replaced by a technician only. In case of any
malfunction refer to "Service" in the "Safety
Instructions" chapter.
ENVIRONMENTAL CONCERNS
Recycle materials with the symbol . Put the
packaging in relevant containers to recycle it. Help
protect the environment and human health by
recycling waste of electrical and electronic
appliances. Do not dispose of appliances marked
with the symbol with the household waste.
Return the product to your local recycling facility or
contact your municipal office.
4
*

WWW.ZANUSSI.COM/SHOP
867351549-A-302021