ZBE Colorpro II Instruction Manual

ZBEColorpro II
Installing the ZBE Colorpro II
Selecting the ZBE Colorpro II option in DP2
How to use the ZBE Colorpro II
The ZBE ColorPro II is designed to color correct large quantities of images. It may be replaced
with your other color input devices. Below are instructionsfor installing and using the device with
DP2.
Installing the ZBE Colorpro II
1. Plug in the ColorPro II to your computers USB port. Microsoft's New Found Hardware Wizard
opens.
2. Click Install from a list or specific location.
3. Click Next.
Page
1
of
5
Installing the ZBE Colorpro II
9/25/2007
file://I:\colorpro.htm

1. Click Browse. Browse to the directory where DP2 is installed and locate the ColorPro
folder.
2. Click Next >.
3. The install window may come back with messages about Windows Logos, click Continue
Anyway.
Page
2
of
5
Installing the ZBE Colorpro II
9/25/2007
file://I:\colorpro.htm

4. Click Finish. You are finished installing the ColorPro II.
Selecting the ZBE Colorpro II option in DP2
1. Start DP2 and click Adjust on the Task Menu. Once the Adjust Images window opens click
the Misc tab. This is where you enable the device in DP2.
2. Click Color Pro II.
How to use the ZBE Colorpro II
Page
3
of
5
Installing the ZBE Colorpro II
9/25/2007
file://I:\colorpro.htm

The ColorPro II can be effective in two modes: Color Mode and Crop mode. When DP2 starts the
device is set to Color Mode. To switch to Crop Mode, press the button (located in front of the
Blue Wheel). This button toggles betweenthe two modes. On the Adjust Images window there is
a status bar (bottom right) that indicates the current mode.
You can make color changes by moving the DRGB color wheels.
To make changes to contrast, gamma, saturation, and rotation, press the Ctrl key plus the correct
color wheel.
Color Wheel Color Result
Black density
Red red
Green green
Blue blue
Ctrl + Color Wheel Color Result
Ctrl + black contrast
Ctrl + red gamma
Ctrl + green saturation
Ctrl + blue rotation
Page
4
of
5
Installing the ZBE Colorpro II
9/25/2007
file://I:\colorpro.htm

To switch to Crop Mode press the correct button (located in front of the blue wheel).
Look at the status bar in the Adjust Image window tomake sure it is set to Crop.
Color Wheel Crop Result
black adjusts zooming
red adjusts image left/right
green adjusts image up/down
blue adjusts angle
Page
5
of
5
Installing the ZBE Colorpro II
9/25/2007
file://I:\colorpro.htm