Zebronics ZEB-Pixaplay 21 User manual

www.zebronics.com
User Manual
LED Projector
ZEB

Dear Customer,
Thank you for purchasing the ZEB-Pixaplay
21 LED projector. Please read the user manual
carefully before usage and save it for future
reference.
Note :
Ÿ To provide a stable power supply, kindly use the
cable provided with the product and connect to a AC
100-240V, 50/60Hz power source.
Ÿ Avoid the self-disassembly of the product as it
results in voiding the product’s warranty.
Ÿ Avoid looking directly at the projector lens while it is
active.
Ÿ Make sure that the projector’s air vents are not
blocked while in use. The device must be kept in a well
ventilated surrounding for proper functioning.
Ÿ It is recommended to turn OFF the projector after a
continuous usage of maximum 6 hours.
Ÿ Place the projector away from water or other
liquids. Avoid water accumulation and ensure good
ventilation.
Ÿ In case of enquiry regarding the projector, email us
at [email protected] or contact us at 044 4000
0004.
Ÿ To know more about Terms and conditions for
warranty policy, please visit
https://zebronics.com/pages/warranty-policy

Features :
Home Theatre Projectors for Movies, TV &
Gaming etc.
Projector comes with HDMI, VGA ,AV IN, AUX
OUT, USB x 2
Built in Speaker
Wide Compatibility
Ceiling Mountable
Remote Control
Dolby Audio
Specification:
Screen size : 111 cm - 508 cm
Native Resolution : 1280 x 720P
Max. Supported
Resolution : 1920 x 1080P
(Max)
Display Technology : LED
Lifespan : 30,000H
Brightness : 3000 lumens
Contrast ratio : 1000:1
Projection Distance : 1.5m - 5.6m
Port Interface : HDMI, VGA ,AV IN,
AUX OUT,USB x 2
Video file format : AVI, MP4, MPG, MPEG1,
MPEG2, MKV, MOV,
FLV, H.264
Input Voltage : AC 100-240V, 50/60Hz

Product Dimension : 24.5 x 16.6 x 8.15 cm
(W x D x H)
Net. weight : 1.31 kg
Package Contents :
Projector : 1 U
Remote Control : 1 U
Power Cord : 1 U
AV cable : 1 U
HDMI Cable : 1 U
QR Code Guide : 1 U
Cotton Swab Pack : 1 U

Product Description

Remote Control
*NOTE :
1. To avoid power shortage, do not mix and use the old and
new batteries.
2. To avoid battery leakage corrosion, if the remote
controller is not used for a long time, please take the battery
out.
SignalSource/
InputMode
Up

Setting Up the Projector
Power cord setup:
Plug-in the power cord into the socket as
described in the image below
Power on/Power off
Press power button on the projector or on
the remote to switch the power On/Off.

Boot Up
After turning on, the projector boots up
within a few seconds and displays the
multimedia input screen .
Focus and Keystone correction
Keystone
If the projector displays the image that is
wider in the top and narrow in the bottom or
vice versa, then use the keystone adjuster to
correct the image to have an even top and
bottom edges.

Image focus
Use the focus adjuster (refer to the product
image) to adjust the focus of the projector until
the picture displayed on the screen is in good
clarity.

Projector Connection
*Could connect multi-device and applications.