Zen Water Filter and Purifier System User manual

USER GUIDE
Warranty
Congratulations on the purchase of your Zen Water Filter and Purifier System.
You are only minutes away from transforming ordinary tap water into pure,
clean, delicious drinking water the way nature intended.
Zen Water warrants to the original purchaser that all parts to arrive free from
damage and defects in workmanship. Before returning any parts, contact us at
[e-mail] or call us at [phone]. A replacement
part can be shipped within 1 to 2 business days.
Care & Maintenance
Do not place unit in direct sunlight. Extended exposure to direct or indirect
sunlight may result in formation of algae / moss.
Do not use Zen Water System with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after the
system.
Do not use detergent to wash Micro Ceramic Filter, Mineral Cartridge or
Mineral Stones.
Do not use hot water (max 85° F / 30° C) in Zen Water System.
IMPORTANT: Check for leaks around the spigot area. If there is a leak,
tighten the magnetic nut. There should not be a leak if the nut is tightened
properly. Do not use if there is a leak.
Allow one full top tank of water to cycle through before consumption.
Discard first tank of water.
The initial set-up and preparation process will take
approximately 45 to 60 minutes.
I. Prep Mineral Stones – 15 to 20 mins
II. Prime Filters – 10 to 15 mins
III. Clean & Check Parts – 15 to 20 mins
IV. Assemble Unit – 5 mins
After this 60-min preparation, you will enjoy months
of delicious drinking water.
In the first few days of use, it will take 2 to 3 hours to
filter through 1 gallon of water. Flow rate will
gradually increase after a few days of use.
About your Zen Water System
What To Expect
See Quick Start Guide next page to get started,
or visit our website at www.zenwatersystems.com to watch our instructional videos.
Before First Use
Filter Replacement & Maintenance
Always use genuine Zen Water replacement filters and parts for optimal
performance and proper fitting. www.zenwatersystems.com
COMPONENT MAINTENANCE REPLACEMENT
Micro Ceramic
Filter
Frequency: Monthly
Maintenance: Scrub ceramic
filter with scour pad or mesh
under cool running water
Every 1 year or 1,000
gallons, whichever
comes first
Mineral Stones
Frequency: Monthly
Maintenance: Boil mineral
stones approx. 15 mins
Every 1 year or 1,000
gallons, whichever
comes first
Water Tanks
Frequency: Every 3 months
Maintenance: Wash with mild
detergent using a soft sponge
Replace tank if
cracked or broken
5-Stage Mineral
Cartridge No maintenance required
Every 6 months or
500 gallons,
whichever comes first
41

QUICK START GUIDE
Prep Mineral Stones
Remove mineral stones from case. Use a
flat screwdriver or a round tip knife. Place
it along the seam and give it a firm push to
pry open the bottom cover.
Boil mineral stones in a pot of water.
Simmer 15 minutes. Drain water. Allow
stones to cool off.
Wash case and rinse thoroughly. Return
stones into case after stones cooled off.
1
2
Prime Filter + Cartridge
Flush 5-Stage Mineral Cartridge under
cool running water for 3 to 5 minutes.
Occasionally tap cartridge UPSIDE DOWN
against side of sink to loosen minerals.
Screw Cartridge Ring onto 5- Stage
Mineral Cartridge.
Use a clean scour pad to scrub Micro
Ceramic Filter under cool running water.
5
6
Prep tanks + Check for leaks Assemble Unit
Fill top tank with tap water
Wash top and bottom tanks with
detergent & non-abrasive sponge.
Assemble Micro Ceramic Filter into top
tank. Place 1 washer on each side of
tank and secure with wing nut.
Attach spigot to bottom tank. Place 1
washer on each side of the tank and
secure with magnetic nut.
8
9
Fill bottom tank with water to test for
leak. Check area around spigot for any
signs of leak. If there is a leak, tighten
nut by a quarter turn.
10
3-5 mins
711
15 mins
Lid
Top Tank
Micro Ceramic Filter
Cartridge Ring
5-Stage Mineral
Cartridge
Middle Ring
Mineral Stones
Bottom Tank
Magnetic Spigot
Base
23
15 mins
3
wing nut
+ washers
4