SPEED CONTROL
Press forwards to increase speed. Press
backwards to brake.Do not increase
speed too suddenly or brake too suddenly
DIRECTION CONTROL
With the Hub motor wheels (5) at the
rear, when set to “FWD” the board will
move forwards when increasing speed.
When set to “BWD” the board will move
backwards when increasing speed
MODE BUTTON
Mode 1: Max. 10 km/h
Mode 2: Max. 20 km/h
To toggle between modes,
push the Speed Control forward
& press the Mode Button at the
same time.The skateboard must
be switched on.
LEARN BUTTON
Pairs the Remote Control with
the skateboard. Your Remote
Control is already paired with
your ZINGO CRUZE. If you lose
your Remote Control,
then use the following
instructions to pair a
new Remote Control:
Switch on both the skateboard & the
Remote Control, then hold down the Power
Button (7) on the skateboard & press the
Learn Button on the Remote Control at the
same time with a pointed object. Hold for 3
seconds until you hear a beep to confirm
that the pairing is successful.
ON/OFF
Switches the remote control On or Off.
The remote will only respond when the
skateboard is also powered on
CHARGE
INDICATOR
LIGHTS
Indicates the
amount of battery
power remaining
• Place your ZINGO CRUZE on a flat, dry surface in front of you. Make sure your
ZINGO CRUZE and Remote Control are both fully charged
• Switch on your ZINGO CRUZE by pressing the Power Button (7). The Power Button
will glow blue when powered on
• Familiarize yourself with the Remote Control (10) as decribed below before
attempting to ride your ZINGO CRUZE
Before riding your ZINGO CRUZE:
• Place your hand through the Safety
Lanyard (as shown in the picture on the right)
before using the remote control
• Place your index finger through the
ergonomically designed hole and use your
thumb to operate the Speed Control
HOW TO RIDE YOUR ZINGO CRUZE
4.
CHARGER PORT
Connect the Remote Control
Charger Cable (11) to a powered-on USB
port to charge the Remote Control
SAFETY LANYARD
Prevents the rider from dropping the
Remote Control