Zinwell ZMT-620HD User manual

Digital Terrestrial Receiver
Quick Setup Guide - Zinwell ZMT-620HD
Step 1 –Connect your digital receiver
After unpacking your digital receiver, connect as shown in the diagram below.
Option 1: HDMI
This is the recommended set up.

Option 2: Composite

Option 3: Component

Step 2 –Start Auto Scan
Once you have the digital receiver connected, turn the power on. Please note the red
light indicates you are in standby so when there is no light the unit is “on”.
The receiver will take approximately 15-20 seconds to power up. To start tuning enter
Menu > Installation > Auto Scan
Step 3 –Enter Password
0 0 0 0

Step 4 –Select Country
New Zealand is highlighted. Select enter.
Step 5 –Tuning in Freeview Channels
A screen showing tuning progress will be displayed (see example below). It will tell you
that the digital receiver is automatically tuning in the Freeview channels. Tuning can take
a few minutes. You do not need to take any action during the tuning process.

And that’s it. You are now ready to enjoy the Freeview experience!
If you have any problems we recommend you check your aerial connection. If you still
can’t get a picture one of the installers listed on the installer directory on our website
should be able to help.
www.freeviewnz.tv