Zio Ciro Subito Cotto MINI 40 User manual

Subito Cotto MINI User Manual - Mod. 40
It is important that the “Subito Cotto” oven will be installed and used only in accordance with
these attached user manual, for your security and to ensure that the oven will functions properly.
We recommend you to read carefully the following instructions before using the oven. The safety
instructions, by themselves, do not eliminate danger completely, and proper accident prevention
measures must always be used.
PLACE AND SUPPORT BASE OF WORKING
Subito Cotto INI oven can be used either in outdoor and indoor places. For internal use verify the
adequate aeration for the room where you use it. For outdoor use it is recommended a place
where there is not wind. The Subito Cotto INI is made of weather resistant materials, but it is
recommended to cover it in non-use times.
Position the oven above a properly floor or base, ensure that can support the weight.
Position the oven far from any combustible material.
BURNER AND GAS CONNECTORS
Subito Cotto INI it is standard configured to operate with GAS GPL. On request, before the
purchasing, there is the possibility to configure the oven with ethane or Propane GAS.
It is necessary to use a pressure regulator for connecting the Subito Cotto INI to GPL cylinder.
This regulator must have the below specifications:
Capability: 7 kg/h
LOW Pressio : 30 mbar
Connect the gas pipe screwing the die in the special grafting under the oven, use a properly gasket.
Use the appropriate gasket with standard pipe.
BURNER TECHNICAL SPECIFICATIONS
Thermal Pote tial > IN 2KW – AX 6KW
GAS Pressure > From 2,5 to 50 mbar
GAS Pipe Size > ½ Inches
Bur er Weight > 1,7 Kg

OVEN CURING AND FIRST FIRING
First firings are necessary for removing humidity from the oven that could be accumulated during
production and transport. Turn on the Subito Cotto INI for the first time for at least three hours,
this pre-heating phase is very important.
RELEASE OF WATER ON THE FIRST FIRING ARE FREQUENTLY AND DO NOT CO PRO ISE THE
PRODUCT GOODNESS.
Note: Due to thermal expansion, small cracks may appear in the dome during the pre-heating
process. Do not worry, this is normal and the quality of your oven will not be compromised.
OVEN COOKING
Switch on the Subito Cotto INI through the piezoelectric by holding down the console
gas regulation, the pilot flame will light up, wait a few seconds with the flame
pilot lights up. Only release the adjusting knob now and adjust the intensity of
desired flame.
To bring the oven to the desired cooking temperature, can use the supplied door, equipped with
the appropriate air intakes. Be careful that this door will quickly become very hot and you will
need to use it properly glove or elbows to avoid sunburns.
Do not leave the oven at full power for more than two hours with the door closed. The INI would
get too high temperatures for any kind of cooking and you could damage the oven.
Once the desired temperature is reached, the oven will be used without a door.
TIPS AND PRECAUTIONS
If placed outdoor protect the oven from rain when it is not used.
The oven must always be dry when used.
Do not turn off the flame with water.
Use a high protection glove to prevent burns from metal door.
Pay attention when you place the metal door. Do not place it on surfaces that not support
high temperatures (plastic, wood, etc.).
Turn off the gas and fire when the oven is not used.
Do not tamper, modify or dismantle the Subito Cotto INI.
DO NOT USE the oven in basements.
FIRE WARNING AND LOCAL DEPARTMENTS
Be careful, place the oven far away from any combustible material. Every local building code is
unique, please consult your local building code or your Fire Department for the exact specifications
for your community. You are responsible for following all local building codes.
TEK. REF. SRL
Office a d Factory: Z.I. Loc. Feurredda SNC – 09088 SIMAXIS, (OR) ITALY
Tel. [phone] – Fax [phone] – Sito Web: www.zio-ciro.com – E-Mail: i [e-mail]
P.IVA 01088030950 – R.E.A. . 129538