Zonda Hobby ESKY 300 V2 User manual

User Manual
Remote Controller
ESKY008083
Esky
FCC ID: 2AVDQ-ESKY008083
Shenzhen Zonda Hobby Co.,Ltd
Rm 609, Block A, Dachong Business Center, #9678 Shennan
Rd. Nanshan District, Shenzhen, China

FCC ID: 2AVDQ-ESKY008083
Made in China
This device complies with part 15 of the FCC rules and industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.
Device types Remote Controller with model ESKY008083 (FCC ID: 2AVDQ-
ESKY008083) has also been tested against this SAR limit. The highest
reported SAR values for Max.SAR is 0.03W/kg. This device was tested for
typical body operations with the back of the handset kept 0mm from the body.
The use of accessories that do not satisfy these requirements may not comply
with FCC RF exposure requirements, and should be avoided.