ZTOZZ HEIMA User manual

     
           
        
                     
                            
                               
                          
     
                                   
          
          

    

       
x20
x4
x2
x2


x4


2" x 1"
       
x1 x1
x1
x1
x2




x1 x1
 

x1
1/4"x 1⁄"
backrest
sleeper cushion rollout storage back cushion
stopper railarmrest 2
armrest 1
throw pillows
hex key hex bolts plastic washer
legswheels Bwheels A

3/8"x2

pivod













Take the pre-assembled rollout drawer and sleeper
cushion out of the carton. Follow the red string and
you’ll nd the hardware pack and the throw pillows
inside the drawer. Fold the drawer back into the original
position and place the assembly vertically as shown.








Screw in the wheels A (part G) using
2x hex bolts with the hex key.
Screw in the wheels B (part H) using
2x hex bolts with the hex key.







Make sure to fold the drawer into a sleeper cushion
and place the assembly so that the wheels are facing
downward.
Take out both armrests and place them as pictured.
Please position the center of the leg (part I) 1,6" from
the edge of the armrest and attach the legs using the
hex bolts as shown.


  
Install one pivot hinge (2)
on each arm using
2x hex bolts on each pivot
with the hex key.












Attach the stopper rail onto the
armrests using hex bolts on each
armrest with the provided hex key.
Please make sure the stopper hooks
are positioned as in illustration.
Insert the plastic washer (F)
on the pivot hinges







Alling the back cushion holes with
the pivot hinges on armrests and insert
it with the plastic washer in between.
  Center the backrest and align it with
the connector hinge, then
push it down. (make sure the facing
area is facing out)









                        


 




Place the sleeper assembly into the sofa base, gently roll it over the
stopper rail until both wheels are on the inside of of stoppers, you’ll
hear a distinct “click” sound.