ZyXEL Communications DX3301-T0 User manual

Quick Start Guide
DX3301-T0
Dual-Band Wireless AX1800
Gigabit Ethernet IAD

Plug one end of the Ethernet cable to the blue
WAN port of the router ,
the other end should connect to the
ONT socket for fibre broadband or the
Ethernet socket for your internet service.
For any device which connects directly to your
router use an Ethernet cable and connect to
one of the four yellow LAN ports .
Plug in power supply and connect to
router .
Turn router power button on .
Check LEDs are lit green on the front.
(This may take a few minutes)
If you're using a virtual landline (VoIP) handset,
plug the Ethernet cable from your phone directly
to one of the four LAN ports on the router .
Full Fibre & Gigafast connections
1a
3
4

3
4
2
1a
1b
or
Superfast Connections
1b
Connect the DSL cable to your router .
If your phone socket has a built in DSL
(top). please plug the cable into the DSL
socket. If not connect via the filter (bottom)
included in the box.

Any question?
Once the router has booted you can connect
to your wireless network from any suitable
device.
The network name and password are printed
on the back of the router along with a QR
code to auto-connect
If you have any further questions setting up,
please visit https://zybre.co.uk
email [email protected]
or call us on 0330 320 2062
Wireless