360 Vision H7016 User manual

H7016
User Manual

Preface
i
Preface
We sincerely appreciate your choice to purchase H7016 product. H 7016 Security
operates on the principle that our customers deserve strong, reliable security
products with an emphasis on value.
This is the user and installation guide for the H7016 embedded DVR.
Please read this manual carefully before you begin using the DVR.
We recommend retaining this manual in a location that can be easily located by the
operator of the system.
Copyright©
No reproduction of any part may take place without the written permission of the
manufacturer in accordance with copyright policy.
H7016 is a trade mark of its manufacturer
Ethernet is a trade mark of Xerox Corporation.
Microsoft, MS -DOS, the Windows logo, Windows and Windows NT. used in the
USA and other countries is a trade mark of Microsoft Corporation.
The manufacturer, importer and agent shall not be responsible for accidental
damage - including injury - and other damage caused by inappropriate use or
operation of this product.
This manual has been made for use with the H7016.
The manufacturer does its best to provide accurate information but cannot be held
responsible for typos or mistakes. Information contained in this document is
subject to change without prior notice.

H7016 User Manual
ii
H7016 User Manual
This is an operating manual for use with the H7016 product.
.
Caution
We strongly recommend that users read all safety cautions carefully before operating
the product, and operate the product appropriately.
Since the indicated cautions contain critical safety information, they must be fully
complied with.
Danger
Risk of death or serious injury. This is the highest priority danger warning.
Warning
Risk of serious or lesser degree of injury. May also cause damage to the
product or to property.
Caution
Risk of minor injury or damage.
Important
Requirements or limitations regarding operation. Users are recommended
to read the relevant details carefully so as to operate the product properly
and without harm.
The above cautions indicate the degree of danger or injury that may occur due to
inappropriate use of the H7016

Caution
iii
Do not score, bend, twist, pull or heat the
power cord. Damage to the power cord
may lead to fire and electric shock.
Do not remove the top casing of the
product. Doing so may result in electric
shock. If internal examination and
maintenance are deemed necessary,
contact the authorized system vendors or
installers.
Do not place heavy objects on top of the
power cord. Damage to the power cord
may result in fire and electric shock.
Do not place containers with liquid or small
metal objects on top of the product. Liquid
or small metal objects getting into the unit
may lead to fire and electric shock.
Please connect the power cord only to the
type of AC outlet indicated in the manual
or product specification. If connected to
other types of power outlet, fire and
electric shock may result.
Do not expose the product to moisture
and dampness. Doing so may result in fire
and electric shock.
Danger
Non-compliance may result in death or serious injury.
These messages contain the highest degree of importance.

H7016 User Manual
iv
Do not modify the product in any way.
Doing so may lead to fire and electric
shock.
In case of lightning, immediately turn off
the power switch and remove the power
cord from the power outlet. Failure to do so
may result in fire and electric shock.
Do not touch the product with wet hands.
Doing so may result in electric shock.
.
Please use only the correct voltage with
the product. Use of incorrect power voltage
may result in fire and electric shock.
If the product is dropped or damaged, turn
off the power switch and remove the power
cord from the power outlet. Continued
operation of the product may result in fire
and electric shock.
In case of smoke or burning odor,
immediately turn off the power switch and
remove the power cord from the power
outlet. Continued operation of the product
may result in fire and electric shock.

Caution
v
Do not leave the power cord or other
cables in passageways or walkways.
Passers-by may trip and fall.
Avoid contact with water or beverages.
Contact with water or beverages may
result in damage that cannot be repaired.
Excessive current from the product and the
camera may result in an electric shock.
Connect the power cord to an external
device only when the products themselves
are disconnected from their power supply.
Warning
Non-compliance may result in a serious or lesser degree of injury.
It may also cause damage to the product or to property.

H7016 User Manual
vi
본제품에 이물질이 묻었을 경우에는 부
드러운 헝겊이나 수건으로 닦아 주십시
오. 이물질을 닦을 때는 절대 화학 용액
(신나, 솔벤트 등)을사용하지 마십시오.
신용카드/ 전화카드 / 통장/ 승차권 등의
자성을 이용한 제품은 본제품 가까이
두지 마십시오.
Static electricity may cause damage to the
internal parts of the product. Please
remove static electricity from your body
before touching the rear panel and internal
electronic parts of the product.
.
.
If this product is damaged beyond repair or
reaches its maximum service life, dispose
of it in compliance with local laws and
regulations regarding the disposal of lead
and plastic waste.
Do not operate or store the product in the
following places:
-An area that is either too cold or too hot.
- An area of high humidity, or in front of an
air-conditioner, or in places subject to
sudden temperature changes.
-An area where there is excessive dust.
- Areas where heat from the product
cannot be emitted through both of the
product's side ventilation openings.
If a foreign substance is stuck to the
product, remove it using a soft cloth or
tissue. Do not use chemical agents
(thinner, solvent, etc.) to remove the
substance.
Do not place credit cards/telephone
cards/bank account books/tickets and
other objects with magnetic properties near
the product.
Caution
Non-compliance may result in minor injury or damage.

Caution
vii
Since the product is designed to record
video data on the hard disk, an error in the
hard disk or other miscellaneous errors
might prevent the product from recording
properly. Periodic maintenance is required
for proper operation of the product
The product is designed for users to
configure their own interface. However a
user configuration error could lead to
operation malfunction. This product should
be set up by certified installers
only.
Since the product is connected - and tightly
coupled - to exterior accessories (camera,
sensor, LAN, Hard Disk, etc.), there is a
risk of malfunction from external causes.
Ensure periodic maintenance by the
certified installers
The product may not work properly if the
power source is unstable or/and if electric
shock occurs. Make sure the correct rated
power is available.
The product is designed to be proof
against electric power failures; however,
damage may occur as a result of power
failure. Current data may be damaged or
data might not be recorded. Make sure to
use an Uninterruptible Power Supply
(UPS).
In this product, 1 Kbyte equals 1,024 bytes,
1M byte equals 1,024,000 bytes and 1G
byte equals 1,024,000,000 bytes.
Important
Denotes requirements and limitations in operation. Users are
recommended to read the relevant details carefully so as to operate
the product properly and without harm.

H7016 User Manual
viii
Table of contents
Preface...............................................................................................................................i
Copyright / Certifications / Registered Trademark / Terms of Use ....................................i
H7016 User Manual ..........................................................................................................ii
Caution..............................................................................................................................ii
Table of contents............................................................................................................ viii
Chapter 1 Introduction and Installation of H7016.......................................................... 1-1
1. About H7016 ........................................................................................ 1-3
2. H7016 specification................................................................................ 1-4
3. System Diagram .................................................................................... 1-5
4. Components........................................................................................... 1-6
Chapter 2 Start H7016 .................................................................................................. 2-1
1. H Outlook............................................................................................... 2-3
(1) Front Design.................................................................................... 2-3
(2) Rear panel and connection locations............................................ 2-10
(3) Remote controller.......................................................................... 2-12
2. How to Install........................................................................................ 2-14
(1) Installation..................................................................................... 2-14
(2) Replace CMOS battery................................................................. 2-20
Chapter 3 Operating H7016.......................................................................................... 3-1
1. Log In..................................................................................................... 3-3
2. Live Mode............................................................................................... 3-4
(1) Select a Channel............................................................................. 3-4
(2) Icon ................................................................................................. 3-5
(3) Pop Up Menu.................................................................................. 3-7
3. PTZ ...................................................................................................... 3-10

Table of contents
ix
4. Search.................................................................................................. 3-12
(1) Simple Search............................................................................... 3-12
(2) Quick backup in playback............................................................. 3-13
(3) Calendar Search........................................................................... 3-14
(4) Event Log...................................................................................... 3-15
(5) Jump to First saved data............................................................... 3-16
(6) Jump to Last saved data............................................................... 3-16
(7) DST (Daylight Saving Time) ......................................................... 3-17
(8) System log .................................................................................... 3-18
Chapter 4 H7016 SETUP.............................................................................................. 4-1
1. Setup Menu............................................................................................ 4-3
(1) About Setup .................................................................................... 4-3
2. System Setup......................................................................................... 4-4
(1) System configuration ...................................................................... 4-5
(2) Disk Configuration......................................................................... 4-10
(3) User configuration......................................................................... 4-11
(4) Configuration................................................................................. 4-13
(5) Shutdown...................................................................................... 4-13
3. Camera ............................................................................................... 4-14
(1) Camera Configuration................................................................... 4-14
(2) PTZ Configuration......................................................................... 4-15
(3) Spot/Sequence configuration........................................................ 4-16
(4) Monitor Configuration.................................................................... 4-17
4. Record ................................................................................................ 4-18
(1) Record Configuration.................................................................... 4-18
(2) Motion/Event configuration ........................................................... 4-25
5. Network................................................................................................ 4-29
(1) Network configuration................................................................... 4-29
(2) Serial Configuration ...................................................................... 4-31
(3) E-mail server................................................................................. 4-32