3M Digital Media Systems 800 Series User manual

July 2006 • 78-6970-9475-9 • Copyright © 2006, 3M Company. All Rights Reserved.
Image Alignment Guide
3
Digital Media System
800 Series

3
Image Alignment
3M™Digital Media System 800 Series
© 3M 2006. All Rights Reserved.
ENGLISH
Image Alignment
Items and/or Actions Required Prior To Performing Alignment
• Safety glasses
• Phillips and flat head screw drivers
1. Connect a video source to the unit and output the
image onto the desired screen or wall.
2. Adjust to desired screen size by unlocking the
arm tabs.
Note: Start with maximizing the arm closest to the
base.
Extend this section first
3. Adjust the focus (picture of focus knob).

4
Image Alignment 3M™Digital Media System 800 Series
© 3M 2006. All Rights Reserved.
ENGLISH
Coarse Alignment Procedure
4. Loosen the base level locking screw.
Locking Screw
Adjustment Screw
5. Turn the adjustment screw to align the top level of
the image.
6. Tighten the locking screw.
If image is still not level:
7. Unlock the arm adjust tab closest to the projection
head. Slightly twist the arm in the direction to
make level.
8. Lock arm adjust tab and slightly tap the projector
head to assure optics alignment has settled.
9. Repeat alignment process as necessary.
10. Proceed to fine alignment procedure only if
necessary.

5
Image Alignment
3M™Digital Media System 800 Series
© 3M 2006. All Rights Reserved.
ENGLISH
Fine Alignment Procedure
11. Use a flat head screw driver to remove the fine
adjustment cover underneath the projector head.
12. Unlock the side-to-side locking screw. This screw
is a pressure screw and only should be turned a
half a turn.
Locking Screw
Side-to-Side
Adjustment Screw
13. Turn the side-to-side adjustment screw to desired
image position.
14. Tighten locking screw.

6
Image Alignment 3M™Digital Media System 800 Series
© 3M 2006. All Rights Reserved.
ENGLISH
15. For fine adjustment to the top left and right
corners of image, unlock the right and left locking
screws.
Locking Screw
Left Side
Adjustment
Screw
Locking Screw
Right Side
Adjustment
Screw
16. Adjust left and right adjustment screws to desired
level.
17. Tighten locking screws.
18. Replace the fine adjustment cover.

Important Notice
All statements, technical information, and recommendations related to 3M’s products are
based on information believed to be reliable, but the accuracy or completeness is not
guaranteed. Before using this product, you must evaluate it and determine if it is suitable for
your intended application. You assume all risks and liability associated with such use. Any
statements related to the product which are not contained in 3M’s current publications, or any
contrary statements contained on your purchase order shall have no force or effect unless
expressly agreed upon, in writing, by an authorized officer of 3M.
Technical Support Contact:
3M Austin Center 3M Canada 3M Mexico, S.a. de C.V. 3M Europe
Building A145-5N-01 P.O. box 5757 Apartado Postal 14-139 Boulevard de l'Oise
6801 River Place Blvd. London, Ontario Mexico, D.F. 07000 95006 Cerge Pontoise
Cedex
Please Recycle
Litho in USA
@3M 2006
78-6970-9475-9