THIS DEVICE COMPLIESWITHPART 15 OFTHE FCC RULES.OPERATION IS
SUBJECT TO THE FOLLOWING TWOCONDITIONS: (1) THIS DEVICE MAY
NOTCAUSE HARMFULINTERFERENCEAND(2)THISDEVICEMUSTACCEPT
ANY INTERFERENCE RECEIVED,INCLUDING INTERFERENCE THAT MAY
CAUSEUNDESIRED OPERATION.
Federal Communications Commission Requirements
The equipment hasbeen testedandfoundto complywith the limits forClassBDigital
Device, pursuant to part 15 of the FCC Rules. Theselimits aredesigned to provide
reasonable protection against harmful interferenceinaresidentialinstallation. This
equipment generates,uses and can radiate radio frequency energyand,if notinstalled
andusedin accordancewith the instruction, maycause harmfulinterferenceto radio
communication. However, there isno guarantee that interference will not occurin a
particular installation. If thisequipmentdoes causeharmful interferenceto radio or
television reception, which can bedetermined byturning theequipmentoffandon, the
useris encouraged totry to correct the interference byone or moreof the following
measures:
lReorient ofrelocate the receiving antenna.
lIncreasetheseparation betweenthe equipment and receiver.
lConnecttheequipment intoan outlet onacircuitdifferent from that to which the
receiveris connected.
lConsult the dealer oranexperienced radio/TV technician for help.
THE CHANGESOR MODIFICATIONSNOT EXPRESSLY APPROVED BY THE
PARTY RESPONSIBLE FOR COMPLIANCE COULD VOIDTHE USER S
AUTHORITYTO OPERATETHE EQUIPMENT.
This device complies with Part 15 ofthe FCC Rules. Operation is subject to the
following two conditions:
(1). this device may not causeharmful interference, and
(2). this device must accept anyinterference received, including interference that may
cause undesiredoperation.
Introduction
Congratulations on your purchase. Your new Wireless BatteryFree Optical
Mouse will offer youwireless freedom, yet no battery is ever needed. Whilst
savingyou the cost ofbatteries, it assures Wrist Comfort, Lightness, Easy Operation
andNo RF-Interference.
BatteryFree Mouse Pad/Mouse Installation:
1. Connect the mouse pad's USB cable to your computer USB port.
2. Red PWR LED On”whenmouse is on the mouse pad.
3. Red PWR LED Blinking”whenmouse is not on the mouse pad.
