Aaeon FWS-7150 User manual

Network Appliance FWS-7150
FWS-7150
1U Rackmount
Network Appliance Platform
1 ATA100, 2 SATA I
2 USB2.0 Ports, Mini PCI
FWS-7150 Manual Rev. A 1st Ed.
April 2009

Network Appliance FWS-7150
i
Copyright Notice
This document is copyrighted, 2009. All rights are reserved. The
original manufacturer reserves the right to make improvements
to the products described in this manual at any time without
notice.
No part of this manual may be reproduced, copied, translated,
or transmitted in any form or by any means without the prior
written permission of the original manufacturer. Information
provided in this manual is intended to be accurate and reliable.
However, the original manufacturer assumes no responsibility
for its use, or for any infringements upon the rights of third
parties that may result from its use.
The material in this document is for product information only
and is subject to change without notice. While reasonable
efforts have been made in the preparation of this document to
assure its accuracy, AAEON assumes no liabilities resulting
from errors or omissions in this document, or from the use of the
information contained herein.
AAEON reserves the right to make changes in the product
design without notice to its users.

Network Appliance FWS-7150
ii
Acknowledgments
All other products’ name or trademarks are properties of their
respective owners.
 Award is a trademark of Award Software International, Inc.
 CompactFlash™ is a trademark of the Compact Flash
Association.
 Intel®, Xeon Quad Core, and Core 2 Duo are trademarks of
Intel®Corporation.
 Microsoft Windows®is a registered trademark of Microsoft Corp.
 ISoundBlaster is a trademark of Creative Labs, Inc.
All other product names or trademarks are properties of their
respective owners.

Network Appliance FWS-7150
iii
Packing List
Before you begin installing your card, please make sure that the
following materials have been shipped:
 1 FWS-7150
 1 Quick Installation Guide
 1 CD-ROM for manual (in PDF format) and drivers
 1 8P KB/MS Cable
 1 IDE Cable
 1 VGA Cable
 1 Screw Accessories
If any of these items should be missing or damaged, please
contact your distributor or sales representative immediately.
Note:
PS/2 keyboard/mouse cable and VGA Cable are optional
accessories, please purchase those cables according to the
following item numbers.
1700060150 PS/2 KB/MS Cable

Network Appliance FWS-7150
iv
Contents
Chapter 1 General Information
1.1 Introduction................................................................1-2
1.2 Features....................................................................1-3
1.3 Specifications............................................................1-4
1.4 General System Information .....................................1-7
Chapter 2 Quick Installation Guide
2.1 Safety Precautions....................................................2-2
2.2 Location of Connectors ............................................. 2-3
2.3 Mechanical Drawing..................................................2-5
2.4 List of Jumpers..........................................................2-8
2.5 List of Connectors .....................................................2-9
2.6 Setting Jumpers ........................................................2-10
2.7 Clear CMOS (JP1) ....................................................2-11
2.8 SM Bus (JP2)............................................................2-11
2.9 CF Power Selection (JP3).........................................2-11
2.10 Front Panel Connector (FP1).................................. 2-11
2.11 Serial Port Connector (COM2)................................ 2-11
2.12 Keyboard/ Mouse Connector (CN1)........................2-12
2.13 VGA Connector (CN2).............................................2-12
2.14 Hard Disk Drive Installation.....................................2-13
Chapter 3 Award BIOS Setup
3.1 System Test and Initialization ...................................3-2

Network Appliance FWS-7150
v
3.2 Award BIOS Setup....................................................3-3
Chapter 4 Driver Installation
4.1 Installation.................................................................4-3
Appendix A Programming the Watchdog Timer
A.1 Programming .........................................................A-2
A.2 ITE8712 Watchdog Timer Initial Program..............A-5
Appendix B I/O Information
B.1 I/O Address Map....................................................B-2
B.2 Memory Address Map............................................B-3
B.3 IRQ Mapping Chart................................................B-4
B.4 DMA Channel Assignments...................................B-4
Appendix C Standard Firewall Platform Setting
C.1 Standard Firewall Platform Setting....................... C-2
C.2 Status LED Sample Code..................................... C-2
C.3 LAN Bypass Mode Sample Code......................... C-5
C.4 Console Redirection ............................................. C-6

Network Appliance FWS-7150
Chapter 1 General Information 1- 1
General
Chapter
1
Information

Network Appliance FWS-7150
Chapter 1 General Information 1- 2
1.1 Introduction
FWS-7150 adopts the VIA C7/ Eden Processor, up to 2.0GHz with
400/800MHz Front Side Bus. (or onboard VIA C7 1.0GHz,
FSB400MHz). Moreover, the chipset is equipped with VIA CN700
+VT8237R+. The system memory features two 240-pin DDRII
400/533 DIMM sockets, total up to 2GB. It deploys five LAN ports
that consist of five PCI 10/100Base-TX Ethernet LAN ports with two
ports bypass function. FWS-7150 condensed appearance
features desktop form factor that fits nicely into a space-limited
environment.
This compact FWS-7150 is equipped with one ATA-100, two
SATA I and CompactFlashTM Type II connector with ATA mode.
In addition, it offers flexible expansion with network products and
features one Mini-PCI Type III expansion socket, two USB2.0
ports and one RS-232 console port on the front panel. The
console port deploys console re-direction that increases the
network security via remote control. All of these designs provide
for a more user-friendly solution.

Network Appliance FWS-7150
Chapter 1 General Information 1- 3
1.2 Features
 1U 5 LAN Ports Network Appliance Platform
 VIA C7/ Eden CPU, Up to 2.0GHz
 240-pin x 2 DDRII 400/533MHz Memory Support, Up
to 2GB
 10/100Base-TX Ethernet x 5 (2 Ports Bypass
Function)
 Ultra ATA-100 Port x 1 & SATA I x 2
 CompactFlashType-II Connector & Mini-PCI Slot
 Parallel LCM with Keypad x 1 & USB2.0 Port x 2 &
RS-232 Console x 1 on the Front Panel
 60W Open Frame Power Supply
 Watchdog Function 1~255 Sec.
 Internal 3.5" Disk Drive Bay x 1

Network Appliance FWS-7150
Chapter 1 General Information 1- 4
1.3 Specifications
System
Form Factor
Processor
1U 5 LAN ports Network Appliance
VIA C7/Eden CPU, up to 2.0GHz (FSB
400/800MHz); onboard C7 1.5GHz (FSB
400MHz)
System Memory
Chipset
240-pin DDRII 400/533 DIMM Socket x 2,
total up to 2GB
VIA CN700 + VT8237R+
LAN
BIOS
IDE
SATA Interface
Solid Storage Disk
Realtek 8100C PCI 10/100Base-TX x 5 (2
ports bypass), RJ-45 x 5
Award Plug & Play FWH BIOS – 512KB
ROM
ATA-100 x 1 channel
SATA I x 2
CFD Type II connector(ATA mode)
Expansion Interface
Watchdog Timer
RTC
Mini PCI Type III Socket
1~255 steps, can be set with software on
Super I/O
Internal RTC
Storage Internal：3.5" Hard Disk (SATA or IDE) x 1
System Fan
Front I/O Panel
4cm Ball Bearing Fan x 2 (Optional)
Power LED x 1, HDD Active LED x 1,
Status LED x 1, Bypass LED x 1, LAN

Network Appliance FWS-7150
Chapter 1 General Information 1- 5
LED x 5, USB x 2, LAN x 5, DB-9
connector x 1
Color Blue
LCM
Power Supply
Dimension
N/A
60W open frame power supply
16.9”(W) x 9.8” (D) x 1.7” (H) (430mm x
250mm x 44mm)—Chassis
8.46 (L) x 6.77” (W) (215mm x
172mm)—Board
Display
VGA Controller
I/O
Serial Port
Keyboard & Mouse
Universal Serial Bus
Environmental
Integrated UniChrome Pro graphics, VGA
pin header
COM port x 2: (Internal Pin Header x 1,
External D-sub x 1)
COM 1: RS-232
COM 2: RS-232 (Pin Header)
Reserved pin header
USB2.0 x 2, dual Type-
A
connector on the
front panel
Operating Temp. 32°F ~ 104°F (0°C ~ 40°C)
Storage Temp. -4°F ~ 140°F (-20°C ~ 60°C)

Network Appliance FWS-7150
Chapter 1 General Information 1- 6
Operating humidity: 10 ~ 80%
Storage humidity: 10 ~ 80% @ 40°C, non-condensing
Vibration 0.5G / 5 ~ 500Hz / operation (3.5” Hard
Disk Drive)
1.5G / 5 ~ 500Hz / non operation
Shock 10G peak acceleration (11 m sec.
duration), operation
20G peak acceleration (11 m sec.
duration), non operation

Network Appliance FWS-7150
Chapter 1 General Information 1- 7
1.4 General System Information
Front Panel
Rear Panel

Network Appliance FWS-7150
Chapter2QuickInstallationGuide2-1
FWS-7150
Chapter
2
Quick
Installation
Guide
Notice:
The Quick Installation Guide is derive
d
f
rom Chapter 2 of the user manual. Fo
r
other chapters and further installation
instructions, please refer to the use
r
manual CD-ROM that came with th
e
p
roduct.
Part No. 2001715010 Printed in Taiwan July 2009

Network Appliance FWS-7150
Chapter 2 Quick Installation Guide 2-2
2.1 Safety Precautions
The installation is intended for technically qualified personnel who
have experience installing and configuring system boards.
The equipment can be installed in a restricted access location (RAL)
only.
A restricted access location is a site location for equipment where
the following criteria apply:
01. Access can only be gained by service persons or by users who
have been trained on the restrictions and the precautions for this
specific site.
02. Access is by means of at least one of the following, special tool,
lock and key, or other means of security, and is controlled by the
authority responsible for the location.
Safety Precautions:
Always completely disconnect the power cord from
your board whenever you are working on it. Do not
make connections while the power is on, because a
sudden rush of power can damage sensitive
electronic components.
Always ground yourself to remove any static charge
before touching the board. Modern electronic devices
are very sensitive to static electric charges. Use a
grounding wrist strap at all times. Place all electronic
components on a static-dissipative surface or in a
static-shielded bag when they are not in the chassis
Risk of explosion if the battery is replaced by an
incorrect type. Dispose of used batteries according to
the instructions.

Network Appliance FWS-7150
Chapter 2 Quick Installation Guide 2-3
2.2 Location of Connectors
Board of FWS-7150
Component side

Network Appliance FWS-7150
Chapter 2 Quick Installation Guide 2-4

Network Appliance FWS-7150
Chapter 2 Quick Installation Guide 2-5
2.3 Mechanical Drawing
Board of FWS-7150
Component Side

Network Appliance FWS-7150
Chapter 2 Quick Installation Guide 2-6
Solder Side

Network Appliance FWS-7150
Chapter 2 Quick Installation Guide 2-7
Mechanical Drawing of FWS-7150