Aaeon FWS-7800 User manual

Network Appliance
FWS- 7 8 00
FWS-7800
1U Rackmount
Network Appliance Platform
1 ATA-100, 2 SATA 3.0 Gb/s
6 USB Ports, 1 Mini-PCI Type 3
FWS-7800 Manual 3rd Ed.
April 28, 2014

Network Appliance
FWS-7800
i
Copyright Notice
This document is copyrighted, 2014. All rights are reserved. The
original manufacturer reserves the right to make improvements to the
products described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated, or
transmitted in any form or by any means without the prior written
permission of the original manufacturer. Information provided in this
manual is intended to be accurate and reliable. However, the original
manufacturer assumes no responsibility for its use, or for any in-
fringements upon the rights of third parties that may result from its
use.
The material in this document is for product information only and is
subject to change without notice. While reasonable efforts have been
made in the preparation of this document to assure its accuracy,
AAEON assumes no liabilities resulting from errors or omissions in
this document, or from the use of the information contained herein.
AAEON reserves the right to make changes in the product design
without notice to its users.

Network Appliance
FWS-7800
ii
Acknowledgments
All other products’name or trademarks are properties of their
respective owners.
AMI is a trademark of American Megatrends Inc.
CompactFlash™is a trademark of the Compact Flash
Association.
Intel®, and Xeon Quad Core, are trademarks of Intel®
Corporation.
Microsoft Windows®is a registered trademark of Microsoft Corp.
ISoundBlaster is a trademark of Creative Labs, Inc.
All other product names or trademarks are properties of their
respective owners.

Network Appliance
FWS-7800
iii
Caution
There is a danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer’s instructions and your local government’s recycling or
disposal directives.
Attention:
Il y a un risque d’explosion si la batterie est remplacée de façon incorrecte.
Ne la remplacer qu’avec le même modèle ou équivalent recommandé par le
constructeur. Recycler les batteries usées en accord avec les instructions du
fabricant et les directives gouvernementales de recyclage.

Network Appliance
FWS-7800
iv
Packing List
Before you begin installing your card, please make sure that the
following materials have been shipped:
1 FWS-7800
1 DVD-ROM for manual (in PDF format) and drivers
1 HDD Power Cable
2 Serial ATA Cable
1 D-Sub 9-pin Cable
1 CPU Heatsink 85mm x 85mm x 26mm
1 Ear Bracket Module, Black
If any of these items should be missing or damaged, please contact
your distributor or sales representative immediately.

Network Appliance
FWS-7800
v
Contents
Chapter 1 General Information
1.1 Introduction................................................................ 1-2
1.2 Features ....................................................................1-3
1.3 Specifications ............................................................ 1-4
1.4 General System Information ..................................... 1-7
Chapter 2 Quick Installation Guide
2.1 Safety Precautions.................................................... 2-2
2.2 Location of Connectors .............................................2-3
2.3 Mechanical Drawings of FWS-7800..........................2-5
2.4 List of Jumpers.......................................................... 2-6
2.5 List of Connectors ..................................................... 2-7
2.6 Setting Jumpers ........................................................2-8
2.7 Clear CMOS / RTC (JP1/JP2)................................... 2-9
2.8 AT/ATX Power Type Selection (JP3)........................2-9
2.9 Compact Flash Card Power Selection (JP4) ............2-9
2.10 Front Panel Connector (FP1).................................. 2-9
2.11 ATX POWER Connector (ATX1)............................. 2-9
2.12 AUX POWER 12 Connector (ATX 2)......................2-10
2.13 VGA PIN HEADER (CN1)....................................... 2-10
2.14 PS2 Keyboard/Mouse Connector (CN2).................2-11
2.15 USB 0/1/2/3 PIN HEADER (CN3/CN4)...................2-11
2.16 PCI-E Power Connector (CN7) ...............................2-11

Network Appliance
FWS-7800
vi
2.17 CPU/SYSTEM FAN Connector
(CPU_FAN1/SYS_FAN_1~3)..........................................2-11
2.18 COM2 RS232 Serial Port PIN HEADER (COM1)...2-12
2.19 LCM & Key Pad Control Connector (LCMA)........... 2-12
2.20 Serial ATA power Connector (Power1~5)............... 2-12
2.21 Installing the CPU and the Heatsink ....................... 2-13
2.22 Rackmount Slide Installation...................................2-19
Chapter 3 AMI BIOS Setup
3.1 System Test and Initialization ................................... 3-2
3.2 AMI BIOS Setup........................................................3-3
Chapter 4 Driver Installation
4.1 Installation .................................................................4-3
Appendix A Programming the Watchdog Timer
A.1 Programming .........................................................A-2
A.2 ITE8718 Watchdog Timer Initial Program..............A-6
Appendix B I/O Information
B.1 I/O Address Map....................................................B-2
B.2 Memory Address Map............................................B-3
B.3 IRQ Mapping Chart................................................B-3
B.4 DMA Channel Assignments...................................B-3
Appendix C Standard Firewall Platform Setting
C.1 Standard Firewall Platform Setting....................... C-2
C.2 Status LED Sample Code..................................... C-3

Network Appliance
FWS-7800
vii
C.3 LAN Bypass Mode Sample Code......................... C-6
C.4 LCM Sample Code ............................................... C-8
C.5 Console Redirection ........................................... C-14

Network Appliance FWS-7800
Chapter 1 General Information 1- 1
General
Chapter
1
Information

Network Appliance FWS-7800
1.1 Introduction
FWS-7800 adopts Intel® Xeon Quad Core™ 3400 series up to 3.06
GHz Processor. The chipset is equipped with Intel®3450. In
addition, the system memory features four 240-pin ECC DDR3
1066/1333 DIMM socket total up to 16GB and supports
dual-channel. FWS-7800 deploys optional four Fiber Ethernet or
eight Gigabit Ethernet (4 ports bypass function). The condensed
appearance of FWS-7800 features 1U form factor that fits nicely
into a space- limited environment.
This compact FWS-7800 is equipped with one Ultra ATA-100,
two SATA3.0 Gb/s and CompactFlashTM Type II connector with
ATA mode. In addition, it offers flexible expansion with network
products and features one Mini-PCI Type 3 expansion slot, six
USB2.0 ports and two RS-232 console ports. The console port
deploys console re-direction that increases the network security
via remote control. Moreover, there is a front panel support
LCM with keypad control that allows for easy access and
operation. All of these designs provide for a more user-friendly
solution.
Chapter 1 General Information 1- 2

Network Appliance FWS-7800
1.2 Features
1U Rackmount 10 LAN Ports Network Appliance
Intel®Xeon Quad Core™ 3400 Series Up To 3.06 GHz
240-Pin Dual-Channel ECC DDR3 1066/1333 SDRAM DIMM
x 4 (Up To 16 GB)
Optional Fiber Ethernet x 4 or Gigabit Ethernet x 8 (4 Ports
Bypass Function)
Ultra ATA 100 Port x 1, SATA 3.0Gb/s x 2
CompactFlash™ Type 2 x 1, Mini-PCI Type 3 x 1
300W Power With Auto Range Input
USB2.0 x 6 (Pin Header x 4, Type A Port x 2 On Front Panel)
Parallel LCM With Keypad x 1, RS-232 Console x 1 On Front
Panel
Watchdog Function 1~255 Sec.
3.5” Internal Disk Drive Bay x 1, Dual 2.5” Internal Disk Drive
Bay x 1 (Optional)
Chapter 1 General Information 1- 3

Network Appliance FWS-7800
1.3 Specifications
System
Form Factor 1U 10-port NetworkAppliance
Processor Intel® 45nm Quad Core™ Xeon 3400
series LGA1156
System Memory 240-pin Dual-Channel DCC DDR3
1066/1333 DIMM Socket x 4, up to 16
GB
Chipset Intel®3450
Ethernet (Optional) 10/100/1000Base-TX Ethernet w/
Intel®82573L x 4
10 Gigabit Fiber LAN w/ Intel®
82599ES, SFP+x 2
Gigabit Ethernet LAN w/ Intel®
82571ES, SFP x 2
Note:FWS-7800 supports “Boots on LAN” function for LAN1 only.
BIOS AMI BIOS 32 Mb SPI ROM
Serial ATA SATA 3.0 Gb/s x 2
SSD CompactFlash Type 2 Connector
(ATA Mode)
Expansion Interface Mini-PCI Type 3 Socket
Watchdog Timer 1~255 steps, can be set with software
on Super I/O
Chapter 1 General Information 1- 4

Network Appliance FWS-7800
RTC Internal RTC
Storage Internal: 3.5” Hard Disk (SATA or IDE)
x 1
System Fan 4 cm Ball Bearing Fan (Optional)
Front I/O Panel Power LED x 1
Bypass LED x 1
Status LED x 1
HDD Active LED x 1
LAN LED x 10 (Optional)
USB2.0 x 2
LAN x 10 (Optional)
DB-9 x 1
LCM Display x 1
Reset Button x 1
Color Black
LCM 16 x 2 characters with 4 keypad control
Power Supply 1U 300W w/ auto range input
Dimension 16.9” x 18.5” x 1.73” (430mm x 470mm
x 44mm)
Power Consumption 95W, Intel®Xeon X3450 2.67 GHz
Display
VGA Controller Pin header reserved for Graphic
display
Chapter 1 General Information 1- 5

Network Appliance FWS-7800
I/O
Serial Port COM port x 2 (Internal Pin Header x 1)
COM 1: RS-232
COM 2: RS-232 (Pin header)
Keyboard and Mouse Reserved pin header
Universal Serial Bus USB2.0 x 6: Dual Type A Connector on
front panel x 2
Pin header x 4 (Internal)
Real I/O Panel PCI-E[x1]/ PCI-X/ PCI Expansion slot x
1 (Optional)
Environmental
Operating Temperature 32oF~104oF(0oC~40oC)
Storage Temperature -4oF~140oF(-20oC~60oC)
Operating Humidity 10~80%
Storage Humidity 10~80% @ 40oC, non-condensing
Vibration 0.5 g rms/ 5~500 Hz/ Operation (3.5”
Hard Disk Drive)
1.5 g rms/ 5~500 Hz/ Non Operation
Shock 10 G peak acceleration (11 m sec.
duration), operation
20 G peak acceleration (11 m sec.
duration), non operation
Chapter 1 General Information 1- 6

Network Appliance FWS-7800
Chapter 1 General Information 1- 7
1.4 General System Information
Front Panel
Console Port
LEDs for Bypass, HDD Active, Status, Power
Reset
2 USB Ports2 GbE Copper Ports
PER-C33L Optional
LCM & Keypad
Control
PER-C31L Optional
Rear Panel
Note: These thumbscrews must be tightened with tools after initial and
subsequent accessible installation.
Power Switch
1 U Power Supply
Thumbscrew
1 USB2.0
(Optional)
PCIe/ PCI Expansion
Slot (Optional)
Thumbscrew PS/2 KB/MS (Optional)

Network Appliance FWS-7800
Chapter2QuickInstallationGuide2-1
FWS-7800
Chapter
2
Quick
Installation
Guide

Network Appliance FWS-7800
2.1 Safety Precautions
The installation is intended for technically qualified personnel who
have experience installing and configuring system boards.
The equipment can be installed in a restricted access location (RAL)
only.
A restricted access location is a site location for equipment where
the following criteria apply:
01. Access can only be gained by service persons or by users who
have been trained on the restrictions and the precautions for this
specific site.
02. Access is by means of at least one of the following, special tool,
lock and key, or other means of security, and is controlled by the
authority responsible for the location.
Safety Precautions:
Always completely disconnect the power cord from
your board whenever you are working on it. Do not
make connections while the power is on, because a
sudden rush of power can damage sensitive
electronic components.
Always ground yourself to remove any static charge
before touching the board. Modern electronic devices
are very sensitive to static electric charges. Use a
grounding wrist strap at all times. Place all electronic
components on a static-dissipative surface or in a
static-shielded bag when they are not in the chassis
Risk of explosion if the battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
Chapter 2 Quick Installation Guide 2-2

Network Appliance FWS-7800
2.2 Location of Connectors
Board of FWS-7800
Component side
COM1
Chapter 2 Quick Installation Guide 2-3

Network Appliance FWS-7800
Solder Side
Chapter 2 Quick Installation Guide 2-4

Network Appliance FWS-7800
2.3 Mechanical Drawings of FWS-7800
Chapter 2 Quick Installation Guide 2-5