A&L Furniture Harmony Home User manual

Assembly Instructions
Harmony Home Adult Bed
(Twin, Full or Queen)
Thank you for choosing Furniture Co.
We hope that this piece brings you many years of enjoyment!
For help with assembling your furniture,
or if you have missing hardware, please email us at
[email protected] or call us at 814-349-8203

PARTS (included)
Headboard (1)
Footboard (1)
Headboard Posts (2)
Side Rails (2)
Mattress Boards (5)
4¾” Bolts (4)
Joint Connector Bolts (8)
1¾” Woodscrews (20)
Allen Wrench (1)
Square Drive Bit (1)
TOOLS NEEDED
Screwgun
STEP 1
To attach the headboard posts to the headboard, insert the screw attached to the post into the headboard
cap & slide in against the headboard. (See photo 1.) If the screw is too tight or too loose you can adjust it
with the Allen wrench. Next insert the 4¾” bolts through the posts & screw into the headboard. Tighten the
bolts using the Allen wrench. (See photos 2 & 3.) Note: Make sure the notches in the posts are on the
same side.
HARDWARE (included)
C
B
A
b
e
a
c
d
STEP 2
Attach the side rails to the headboard & footboard. Place the side rails in the notch in the posts with the
hanger bolts going in the predrilled holes & fasten with the 8 joint connector bolts. Tighten with the Allen
wrench. (See photos 4 & 5.)
photo 1 photo 2
C
b
C
C
a
a
photo 3
photo 4
A
A
D
D
photo 5

B
Ac
E
D
E
STEP 3
Evenly space the mattress boards on the side rails. (See photo 6.) Screw the 1¾” woodscrews through the
mattress board into the side rails using a screwgun & square drive bit. (See photos 7 & 8.)
photo 6 photo 7 photo 8
D
EE
E
D
EEE