A&L Furniture Poly 33 Square Dining Table User manual

Assembly Instructions
Poly 33” Square or Round
Dining/Bar Table
Thank you for choosing Furniture Co.
We hope that this piece brings you many years of enjoyment!
For help with assembling your furniture,
or if you have missing hardware, please email us at
[email protected] or call us at 866-896-5747

Pedestal (1)
HARDWARE (included)
2” Screws (4)
Flange Nuts (8)
Square Drive Bit (1)
TOOLS NEEDED
7/16” Wrench or Socket
Screwdriver or Drill
Table Feet (4)
STEP 2
Insert the bolts in the ends of the table feet into the predrilled holes in the bottom of the pedestal. Put
flange nuts on the inside & tighten with the 7/16” wrench or socket. Make sure feet are turned like photo
shows.
b
c
a
STEP 1
Lay table top upside down on a clean surface that won’t scratch top. Insert the end of the pedestal that
does not have the predrilled holes into the square in the center of the top. Push all the way down against
the top then fasten with the 2” screws in the predrilled holes. (Pedestal does not have predrilled holes as
screws are self drilling.)
PARTS (included)
Square or
Round Top (1)
a
a