Accusplit Alliance 1520 User manual

WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer onto
your belt or the top edge of your pants or skirt. It should fit snugly
and level, above one knee.
Note: The pedometer should be as vertical as possible. Walkers
with larger stomachs may find it helpful to wear the pedometer
farther back on the body, toward one hip.
The cover must be closed for the pedometer to work. To avoid
losing or dropping your pedometer, use the included leash and clip
to fasten the pedometer securely to your clothing.
ACTIVITY PEDOMETER
OPERATING INSTRUCTIONS
ACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA
800-935-1996 • 925-290-1900 • FAX [phone] • www.ACCUSPLIT.com • [e-mail]
ACCUSPLIT®
ALLIANCE 1520
Congratulations on taking the first step to wellness
with your purchase of an ACCUSPLIT pedometer.
It’s easy to set up your new pedometer.
Just follow the steps below, and start walking!
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset: Press
and hold yellow RESET button for at least two seconds to
reset to zero.
AUTO MOVEMENT SENSOR
1. To filter out random movements, the unit remains in
standby mode until 5 continuous steps are registered.
Only then are the 5 steps calculated in, and an Active
indicator “▲” appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds
the timer pauses and the unit switches to standby status
(Active indicator “▲” disappears).
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to
replace the battery. Your pedometer uses one Type LR44
1.5 volt alkaline battery. To replace:
1. Insert a coin into the slot on the bottom of the case, and
twist counterclockwise to loosen the case front. Lift case
front away.
2. Using a pen or other thin object, push battery sideways
out of its holder. Replace it with a new battery. The
battery’s positive (+) terminal should be FACE UP while
you put it into the pedometer.
3. Align case front over the pedometer and press gently to
snap cover back into place, starting with top.
AccuSTEP 10000 ORG RESET
ACTIVITY
PEDOMETER
STEP
ACCUSPLIT®ALLIANCE 1520
0 00508
RESET button
960-044
First, loop the
pedometer clip
Next, loop the metal clip,
then clasp clothing
Or, loop a
badge holder,
then put into pocket
(Badge holder not included)
Or, loop a belt or
belt loop
REGISTER NOW Please return
your AL1520 Registration to the
Repair Center address in the
warranty, and we will let you
know about future products.
Email (preferred)
User
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label inside the lid of the pedometer.
DISPLAY MODES
• STEPS
Counts steps taken since last RESET.
Reset daily to count each day’s steps.
Opening your pedometer: You must open
the pedometer to see your results. The unit is
most easily opened while you are wearing it.
To open unit while wearing, place your thumb
on the tab at top. Use your thumb to pull
the cover up and away from
your body. If not wearing the
pedometer, turn the unit so that
the back side is facing you (see
images at left). Grasp the belt
clip with one hand, and then
open as described above.
Attaching the Leash: Attach the pedometer to the leash by looping
the leash around the pedometer belt clip. Next, clasp the waistband
of your clothing with the Attached clip. You can also use a safety pin
to fasten the leash to your clothing, loop the leash through your belt
or belt loop or use a badge holder.
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it will
automatically begin to record your steps.