ADAPT LOGGERS PROTON S100 User manual

USER MANUAL
Product Overview
Operational Overview
Product Anatomy
USB Single-Use Temperature Data logger that generates PDF and CSV reports at the end
of the trip. Needs no additional software. Integrated with high precision temperature
sensor, USB 2.0, and plastic enclosure. Rely on the sturdy IP-graded Proton S100 to
monitor your food and pharma shipments.
PROTON S100
docs.adaptloggers.com/protons100
01.
02.
03.
04.
05.
USB Connector
Status LED
Violation LED
Button
Device ID Bar Code
06. Device ID/QR Code
Sample PDF Report Output
Charge Scan Pair Monitor
Configure
and assign
to asset
01
02
03
PLACE
Place the device
in your shipment.
GET REPORT
Press the button for 3 seconds
to end the trip, and connect
through USB to get trip report.
Temperature
Humidity
Temperature
Humidity
%
START
Press the button for 3
seconds to start.
For further queries, please drop a mail to [email protected]om or call us at [phone]
PROTON | RELIABLE SINGLE USE USB
TEMPERATURE DATALOGGER
04
05
06

For detailed instructions on how to use the software, please visit
01
PROTON S100
Status Request
Operational Instructions
Action Required
Start recording
Stop recording
Download report
Status request by single click of the button will have the following possibilities:
Status LED blinks once
Press 3 secs
Press 3 secs
Connect device and
press button once
Blinks 10 times
Glows constantly for 5 secs
Instruction
LED display indication observed Status indicated
Confirmation Indication
04
Press the button for 3 secs to
stop the trip. The LED stops
blinking and glows for 5 secs
continuously to indicate that
the trip is stopped.
02 03
Press the button for 3 secs to start the
trip (the status LED starts blinking to
show that the trip started) and place
the device in the package
The trip recording starts
only after 30 mins from the
start of the trip. This is the
default preset pre-cooling
period. The trip cannot be
stopped during this
pre-cooling period.
05
Connect the USB of the data
logger to a PC to access the
PDF and CSV reports
Status LED blinks 10 times
Status LED blinks 10 times
Alarm LED glows
Status LED glows for 10 seconds
Alarm LED glows
pre-rec mode
Recording started and
no violation occured
Recording started and
violation has occured
Trip ended, no
violation occured
Recording ended and at least
one violation has occured
www.adaptloggers.com+91-8639739890[email protected]om
single
click of
button
02
docs.adaptloggers.com/protons100
Click the button and check the
status LED. It should glows
once. This means the device is
in good working condition. If
the LED glows continuously for
5 secs, the device is used