Addonics Technologies ADSAIDE44 User manual

Technical Support
If you need any assistance to get your unit functioning properly, please
have your product information ready and contact Addonics Technical
Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/
T E C H N O L O G I E S
www.addonics.com
SATA to 44-Pin
IDE Converter
(ADSAIDE44)
User Guide

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/
Overview
Front View
Back View
Jumper Settings
Master Slave Cable Select
1
3
4
2
1. 44-pin IDE Connector
2. SATA Power and Data Connector
3. Master, Slave & Cable Select
Jumpers
4. Pin 1 Marker
NOTE: To set the SATA hard drive as a Master Device when connected to an IDE channel,
do not install a jumper. As a Slave Device short the middle pins.

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/
Installation
1
1. 15-pin SATA Power & 7-pin Data
Connector
Step 1. Locate the SATA connector
of your 2.5” SATA drive.
Step 2. Connect the converter
board to the SATA connector of the
hard drive.
Step 3. (Optional) Connect the IDE
ribbon cable to the 44-pin connector
on the converter. The red edge of
the ribbon cable needs to line up to
pin 1 marker of the 44-pin connec-
tor. The other end of the ribbon
cable will be connected to your
motherboard’s 44-pin IDE channel.

www.addonics.com
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
CONTACT US