Addonics Technologies ADSSSAI44 User manual

ADDONICS TECHNOLOGIES
Model: ADSSSAI44
Installation Guide
Front View
Jumper Settings
Master Slave Cable Select
Note: To set the slim ATAPI SATA drive as a Master
Device when connected to an IDE channel, you
need to short the top pins located on the converter
by placing a jumper. As a Slave Device short the
middle pins.
1. Locate the slim SATA ATAPI connector of your optical
drive.
2. Connect the converter board to the Slim SATA ATAPI
connector of the optical drive. Secure the adapter using
screws.
3. (Optional) Connect the IDE ribbon cable to the 44-pin
connector on the converter. The red edge of the ribbon
cable needs to line up to pin 1 marker of the 44-pin
connector. The other end of the ribbon cable will be
connected to your motherboard’s 44-pin IDE channel.
TECHNICAL SUPPORT
Email: http://www.addonics.com/sales/
Internet: http://www.addonics.com
Technical Support (8:30 am to 6:00 pm PST)
Phone: [phone]
Email: http://www.addonics.com/support/ticketid/
44-pin IDE Connector
Slim ATAPI SATA
Power and
Data Connector
Master, Slave &
Cable Select
Jumpers
Pin 1 Marker
44-pin IDE ribbon cable
Screw hole
Screw hole