ADJ Mega Go Bar 50 Use and care manual

BATTERY REPLACEMENT
Start by removing both bracket end caps. Unscrew the four phillips screws that hold each end in
place.
The following instructions will help you replace your dead battery in the Mega Go Bar 50. To replace
the battery you need to carefully follow these instructions. If you have any questions please contact
American DJ customer support.
Customer Support: American DJ provides a customer support line, to provide set up help and to answer any
question should you encounter problems during your set up or initial operation. You may also visit us on the
web at www.American DJ.com for any comments or suggestions. Service Hours are Monday through Friday
8:00 a.m. to 4:30 p.m. Pacic Standard Time.
Voice: [phone]
Fax: [phone]
E-mail: [e-mail]

Once the bracket end caps have
been removed, slide out the plastic
LED cover.
After you have removed the LED
cover. Look carefully at the LED strip.
You should see an area at one end
where the LED strip seperates. At that
end, slide the LED strip out, so that
small strip is removed from the hous-
ing. It is still connected to the other
strip, so do not try to fully remove it.
After this strip is out of the housing.
Slide the larger LED strip back the
opposite way.
Slide the strip until the full battery
housing is shown. This is as far as
you need to slide the LED strip. Slid-
ing it any farther could seperate wires
and cause damage.

Carefully disconnect the LED wire
harness from the PC board.
After disconnecting the wire harness,
“ip” the bar over so the rear is facing
up. Remove the two phillips screws
that secure the battery bracket.
After unscrewing and removing the
screws, “ip” the unit back over, and
carefully remove the battery bracket.

Disconnect the IR sensor cable from
the PC board.
Disconnect the DMX In connection
cable.
Disconnect the DMX Out connection
cable.

Disconnect the battery cable.
Carefully remove the battery.