16) Keep upper locking lever facing towards outside of
circle.
17) Loosen handle.
19) Adjust upper arm so receiving plate is at a 15-20°
angle. Tighten to mounting surface.
20) Lock handle. 21) Locate ladder locking pin.
22) Pull pin and rotate a quarter turn to hold open. 23) Slide ladder stud plate onto circle receiving plate. 24) Rotate ladder locking pin a quarter turn back into
locked position.
25) For additional safety and stability, insert ice screws in
the ice screw holes.
26) For ease of raising and lowering ladder, insert a utility
rope through back hole and tie to front hole.
27) Run rope through upper grip loop and anchor away
from for entry point.
28) Leave enough slack to allow for lowering and raising
of ladder.
29) Enter and exit water as needed. Use rope to assist in
raising and lowering lower ladder section.
18) Using handle on circle rotate circle so bottom grip
touches underside of mounting surface.
REVERSE ORDER TO PUT BACK
INTO STORAGE MODE
(See additional steps, maintenance and
warnings on back page)
Setup Continued
