Advantech PCM-9579 Installation and operation manual

PCM-9579 Startup Manual 1
PCM-9579 EBX ULV Intel Celeron / LV Intel
Pentium III SBC with CPU, VGA/ LCD, LVDS,
Ethernet, and Audio
Startup Manual
Before you beg in installing your card, please make sure
that the following materials have been shipped:
• 1 PCM-9579 all-in-one single board computer
• 1 startup manual
• CD-ROM or disks for utility, drivers, and manual (in PDF
format)
• 1 power cable p/n: 1703080101
If any of these items are missing or damaged, contact your
distributor or sales representative immediately.
Note: For detailed contents of the PCM-9579,
please refer to the enclosed CD-ROM or disk
(in PDF format)
.
Standard SBC Functions
• CPU: Embedded Intel® Ultra Low Voltage Celeron™
or
Low Voltage Pentium® III Processor, on die 32KB LI
cache memory ULV Celeron-400 (PCM-9579F-J0A1),
ULV Celeron-650 (PCM-9579F-M0A1), LV Pentium III-
933 (PCM-9579F-R0A1)
• BIOS: Award 256 KB Flash memory
• System memory: One DIMM socket accepts 64 MB up
to 512 MB SDRAM
• 2nd cache memory: 256/512 KB on the processor
• Enhanced IDE interface: Two channels supports up to
four EIDE devices. BIOS auto-detect, PIO Mode 3 or
Mode 4, UDMA 33 transfer. Primary IDE support up to
UDMA 66/100 mode
• FDD interface: Supports up to two FDDs
• Serial ports: Four serial RS-232 ports, COM1, 3, 4: RS-
232, COM2: RS-232/422/485
• Parallel port: One parallel port, supports SPP/EPP/ECP
mode
• Infrared port: Shared with COM2
• Keyboard/mouse connector: Supports standard PC/
AT keyboard and a PS/2 mouse
• Power management: Supports power saving modes
including Normal/Standby/Suspend modes. APM 1.2
compliant
• Watchdog timer: 62 level timer intervals
• USB: Four universal serial bus ports
• Expansion: One PCI slot and PC/104 plus connector for
ISA and PCI I/O board
Solid State Disk
• Supports one 50-pin socket for CFC type I/II
• Supports M-Systems DOC®2000
VGA/LCD Interface
• Chipset: VIA Twister chip with integrated Savage4 2D/
3D/Video Accelerator
• Frame buffer: Supports 8/16/32MB frame buffer with
system memory
• Interface: 4X AGP VGA/LCD interface, Support for 9,
12, 15, 18, 24, 36 bit TFT and 16- or 24-bit DSTN panel
• Display mode: CRT Modes: 1920 x1440 @16bpp, 1280
x 1024@16bpp (60Hz), 1024 x 768@16bpp (85Hz);
LCD/Simultaneous Modes: 1280 x 1024@16bpp (60Hz),
1024 x 768@16bpp (60Hz)
• LVDS: Supports 2 Channel 18bit LVDS interface
Packing List Specifications
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/epc
For technical support and service, please visit our
support website at:
http://service.advantech.com.tw/eservice/
This manual is for the PCM-9579 series Rev. A1.
Part No. 2006957901 2nd Edition
September 2003
PCM-9579 EBX ULV Intel Celeron SBC with CPU, VGA/LCD, LVDS, Ethernet, and Audio

2 PCM-9579 Startup Manual
TV-out (optional)
• Chipset: VIA VT-1622
• Supports NTSC, NTSC-EIA (Japan) and PAL TV formats
• Provides Composite video and S-video outputs via RCA
(composite) connector and S-video connector
• Supports 320 x 200 up to 1024 x 768 input resolutions
• Supports Windows®95/98 and Windows NT drivers
• Over-scan, under-scan and position adjustable
• Auto-detection of TV presence rnet Interface
Ethernet interface
• Chipset: RTL 8139DL
• Ethernet interface: IEEE 802.3u 100BASE-T Fast Ethernet
compatible
• I/O address switchless setting
• Built-in boot ROM
Audio Function
• Chipset: VIA 82C686
• Audio controller: AC’97 ver. 2.0 compliant interface
• Audio interface: Microphone in, Line in, CD audio in, line
out, Speaker L, Speaker R
Mechanical and Environmental
• Dimensions (L x W): EBX form factor, 203 x 146 mm (8" x
5.75")
• Power supply voltage: single +5V or +5V & +12V
(+12V better audio quality), see JP7 definition
• Power requirements:
Max.:
4.5A @ +5V (with 256MB, ULV Celeron-650)
Typical:
2.99A @ +5V (with 256 MB DRAM, ULV Celeron-400 CPU)
3.29A @ +5V (with 256 MB DRAM, ULV Celeron-650 CPU)
• Operating temperature: 0 ~ 60°C (32 ~ 140°F)
• Weight: 0.64 kg (weight of total package)
The board has a number of jumpers that allow you to configure
your system to suit your application.
The table below lists the function of each of the jumpers and
connectors.
PCM-9579 Jumpers
Jumpers and Connectors
Jumpers
Label Function
JP1 PCI VIO select
JP2 LAN controller power select
JP3 DOC2000 address select
JP4 CMOS clear
JP5 Watchdog timer action
JP6 COM2 RS232/422/485 setting
JP7 Audio power setting
Connectors
Label Function
CN1 TV-out connector
CN2 Audio CD in connector
CN3 ATX Power Standby connector
CN4 Audio connector
CN5 EBX Main Power connector
CN6 Inverter Power connector
CN7 Panel Back-Light VR connector
CN8 CRT display connector
CN9 LVDS connector
CN10 LCD 20-Pin Connector (36bits)
CN11 LCD 20-Pin Connector (24Bits)
CN12 Ethernet connector
CN13 Power & HDD LED connector
CN14 IDE hard drive connector (secondary)
CN15 Parallel port connector
CN16 IDE hard drive connector (primary)
CN17 PC/104 plus (ISA + PCI) expansion
CN18 Floppy drive connector
CN19 COM port connector
CN20 USB channel 1, 2 connector
CN21 N/A
CN22 reset button connector
CN23 ATX power on/off switch connector
CN24 IR connector
CN25 Keyboard and PS/2 mouse connector
CN26 CFC connector
CN27 Peripheral negative power input connector
CN28 USB channel 3, 4 connector (optional)
Fan1 CPU fan power connector
˝ˣˊ
˝ˣ˄
˝ˣˆ
˝ˣˈ
˝ˣˉ
˝ˣˇ
˝ˣ˅

PCM-9579 Startup Manual 3
PCM-9579 Connectors (component side)
PCM-9579 Mechanical
JP1 PCI VIO select
1-2 VIO=5 V*
2-3 VIO=3 V
JP2 LAN controller power select
1-3, 2-4 Normal Power *
3-5, 4-6 Wake-On-LAN Power
JP3 DOC2000 address setting
Pins 1-2 Pins 3-4 Pins 5-6 Address
closed open open D4000h
open closed open DC000h
closed closed open CC000h
closed open closed D0000h
open closed closed D8000h
open open open OFF
JP4 CMOS clear
Closed pins Result
1-2 Normal (3 V battery on)*
2-3 Clear CMOS
JP5 Watchdog timer action
Closed pins Result
1-2 System reset*
2-3 IRQ11
JP6 COM2 RS-232/422/485 select
Pins RS-232* RS-422 RS-485
1-2 Open Open Closed
3-4 Open Closed Open
5-6 Closed Open Open
7-9 Closed Open Open
8-10 Closed Open Open
9-11 Open Closed Closed
10-12 Open Closed Closed
13-15 Closed Open Open
14-16 Closed Open Open
15-17 Open Closed Closed
16-18 Open Closed Closed
JP7 Audio power source selection
Closed pins Result
1-2 by 12V (default)
2-3 by 5V
(when input power is 5V DC only, please select this
one)

4 PCM-9579 Startup Manual
PCM-9579 Mechanical Drawing
PCM-9579 Connectors (solder side)
PCM-9579
PCM-9579