AEG DD 8890 User manual

DD 8890
CHDD 8820
CHDD 8890
Dunstabzugshaube
Afzuigkap
Hotte aspirante
Cooker Hood
Campana extractora
Montage- und Gebrauchsanweisung
Installatie- en gebruiksaanwi zing
Notice dutilisation et dinstallation
Operating and Installation Instructions
Instrucciones de monta e y mane o

52
Contents
Safety warnings 53
For the user 53
For the installer 53
Description of the Appliance 55
Extractor ersion 55
Filter Version 55
Control Panel 56
Control de ice for grease and charcoal filters 57
Grease filter LED (F) 57
Charcoal filter LED (C) 57
Resetting the saturation indicator 57
Maintenance and care 58
Cleaning the hood 58
Metal grease filter 58
Remo ing the metal grease filter 58
Charcoal filter 59
Changing the light bulb 60
hat to do if 61
Special accessories 62
Technical assistance service 62
Technical Specifications 63
Mounting accessories included 63
Electrical connection 64
Wall unit mounting 65
Printed on recycled paper
AEG - putting words into action

53
Sa ety warnings
For the user
 The cooker hood is designed to extract unpleasant odours from the
kitchen, it will not extract steam.
 Always co er lighted elements, to pre ent excess heat from
damaging the appliance. In the case of oil, gas and coal fired
cookers it is essential to a oid open flames.
 Also, when frying, keep the deep frying pan on the cooker top/
cooker under careful control.
 The hot oil in the frying pan might ignite due to o erheating.
 The risk of self-ignition increases when the oil being used is dirty.
 It is extremely important to note that o erheating can cause a fire.
Never carry out any flambé cooking under the hood.
Always disconnect the unit from the power supply before
carrying out any work on the hood, including replacing the
light bulb (take the cartridge fuse out of the fuse holder or switch
off the automatic circuit breaker).
It is very important to clean the hood and replace the filter at
the recommended intervals. Failure to do so could cause
grease deposits to build up, resulting in a fire hazard.
 The appliance is not intended for use by young children or infirm
persons without super ision.
 Young children should be super ised to ensure that they do not play
with the appliance.
 ARNING - Ensure that the appliance is switched off before
replacing the lamp to a oid the possibility of electric shock.
For the insta er
 When used as an extractor unit, the hood must be fitted with a
150mm diameter hose.
 Should there already be a pipe of diameter 125 mm that ducts to
the outside through the walls or roof, it is possible to use the 150/
125 mm reduction flange pro ided. In this case the hood will be
slightly noisier.
hen installing the hood, make sure you respect the following
minimum distance from the top edge of the cooking hob/ring
surfaces:
electric cookers 500 mm
gas cookers 700 mm
coal and oil cookers 750 mm min.

54
 The national Standard on fuel-burning systems specifies a maximum
depression of 0.04 mbar in such rooms.
 The air outlet must not be connected to chimney flues or combus-
tion gas ducts. The air outlet must under no circumstances be
connected to entilation ducts for rooms in which fuel-burning
appliances are installed.
 The air outlet installation must comply with the regulations laid down
by the rele ant authorities.
 When the unit is used in its extractor ersion, a sufficiently large
entilation hole must be pro ided, with dimensions that are approxi-
mately the same as the outlet hole.
 National and regional building regulations impose a number of
restrictions on using hoods and fuel-burning appliances connected
to a chimney, such as coal or oil room-heaters and gas fires, in the
same room.
 Hoods can only be used safely with appliances connected to a
chimney if the room and/or flat (air/en ironment combination) is
entilated from outside using a suitable entilation hole approxi-
mately 500-600 cm2 large to a oid the possibility of a depression
being created during operation of the hood.
 If you ha e any doubts, contact the rele ant controlling authority or
building inspectors office.
 Since the rule for rooms with fuel burning appliances is outlet hole
of the same size as the entilation hole, a hole of 500-600 cm2,
which is to say a larger hole, could reduce the performance of the
extractor hood.
 If the hood is used in its filtering function, it will operate simply and
safely in the abo e conditions without the need for any of the
aforementioned measures.
 When the hood is used in its extractor function, the following rules
must be followed to obtain optimal operation:
 short and straight outlet hose
 keep bends in outlet hose to a minimum
 ne er install the hoses with an acute angle, they must always
follow a gentle cur e.
 keep the hose as large as possible (preferably the same diam-
eter as the outlet hole).
 Failure to obser e these basic instructions will drastically reduce the
performance and increase the noise le els of the extractor hood.

55
Description o the Appliance
 The hood is supplied as an extractor unit and can also be used with
a filtering function by fitting one charcoal filter.
 You will need an original AEG charcoal filter for this function
(A ailable from your local AEG Ser ice Force Centre).
Only for CHDD 8890: The cooker hood is supplied ready for use as
a recirculation hood and may be used for extraction by remo ing the
charcoal filter which has been fitted inside the cooker hood.
Extractor version
 In this ersion fumes are extracted to the
outside ia a hose connected to the
coupling ring. Fig. 1.
 In order to obtain the best performance the
hose should ha e a diameter equal to the
outlet hole.
Should there already be a pipe of diameter
125 mm that ducts to the outside through
the walls or roof, it is possible to use the
150/125 mm reduction flange pro ided. In
this case the hood will be slightly noisier.
Fi ter Version
 The air is filtered through a charcoal filter and returned to the
kitchen.
 You will need an original AEG charcoal filter for the filtering function.
(See Special Accessories).
 Optionally, the position of the chimney elements can be changed.
When using the hood in the filter ersion the chimney must be fixed
at the top, with the air outlet grill at the side.
Fig. 1
D