AEG DGK6681HM User manual

USER
MANUAL
EN User Manual
Cooker Hood
DGK6681HM
DGK6981HM
DGK6281HM

CONTENTS
1. SAFETY INFORMATION AND INSTALLATION...................................................2
2. PRODUCT DESCRIPTION...................................................................................3
3. DAILY USE........................................................................................................... 3
4. CARE AND CLEANING........................................................................................ 5
5. TROUBLESHOOTING..........................................................................................6
6. ENVIRONMENTAL CONCERNS..........................................................................7
FOR PERFECT RESULTS
Thank you for choosing this AEG product. We have created it to give you
impeccable performance for many years, with innovative technologies that help
make life simpler – features you might not find on ordinary appliances. Please
spend a few minutes reading to get the very best from it.
Visit our website to:
Get usage advice, brochures, trouble shooter, service and repair information:
www.aeg.com/support
Register your product for better service:
www.registeraeg.com
Buy Accessories, Consumables and Original spare parts for your appliance:
www.aeg.com/shop
CUSTOMER CARE AND SERVICE
Always use original spare parts.
When contacting our Authorised Service Centre, ensure that you have the
following data available: Model, PNC, Serial Number.
The information can be found on the rating plate.
Warning / Caution-Safety information
General information and tips
Environmental information
Subject to change without notice.
1. SAFETY INFORMATION AND INSTALLATION
WARNING!
Refer to the separate
Installation Instructions
booklet for Safety
Information and Installation.
Read carefully the Safety
chapters before any use or
maintenance of the
appliance.
www.aeg.com2

1
1"
2
WARNING!
Before connection to
electricity make sure the
blower support has been
removed from the motor.
2. PRODUCT DESCRIPTION
2.1 Control panel overview
1 2 3 4 5 6
Function Description
1Lamp Turns the lights on and off.
2First speed / Off The motor switches to first speed level. Second press
turns off the appliance.
3Second speed The motor switches to second speed level.
4Third speed The motor switches to third speed level.
5Maximum speed The motor switches to maximum speed level. After 5
minutes appliance switches to third speed.
6
Timer Turns off the appliance after 5 minutes. Reminds to
clean or replace the filter. Refer to Filter notification in
Daily use chapter.
3. DAILY USE
3.1 Using the hood
Check the recommended speed
according to the table below.
ENGLISH 3

While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones or burners, gentle
frying.
While boiling and frying big quantities of food without a lid, cooking on multi‐
ple cooking zones or burners.
While boiling and frying big quantities of food without a lid, big humidity.
It is recommended to leave
the hood operating for
approximately 15 minutes
after cooking.
The control Panel is a
sensor field. To operate the
hood touch the symbol
exactly in the middle for at
least 1 second.
To operate the hood:
1. Open the glass with control panel
symbols.
2. Touch the to switch on the
appliance.
3. If needed, change the speed by
touching the desired symbol.
To turn off the appliance touch
again.
3.2 Timer
This function allows to turn off the
appliance after 5 minutes of operating.
The function can be used only if the
appliance operates on first 3 motor
speeds.
1. Touch the symbol.
Timer starts to flash.
2. After 5 minutes the appliance turns
off.
To turn off the function touch again.
3.3 Hob²Hood function
It is an automatic function which
connects the hob with a hood. Both the
hob and the hood have an infrared signal
communicator. Speed of the fan is
defined automatically on basis of mode
setting and temperature of the hottest
cookware on the hob. You can also
operate the fan using the hob manually.
The function can be activated from panel
of the hob.
Led lamp switches on when the
connection is established between the
hob and hood.
The element underneath the
hood (1) is a signal receiver
of the function.
For more information how to
use the function refer to the
hob user manual.
3.4 Filter notification
Filter alarm reminds to change or clean
the charcoal filter and clean the grease
filter.
• After 40 hours of usage, the symbol
turns on for 30 seconds. The
grease filter must be cleaned.
www.aeg.com4

• After 160 hours of usage, the symbol
flashes for 30 seconds. The
grease filter must be cleaned and
charcoal filter must be replaced or
cleaned.
Refer to cleaning the grease
filter in care and cleaning
chapter.
Refer to cleaning the
charcoal filter or replacing
the charcoal filter in care and
cleaning chapter.
To reset the function touch for 3
seconds.
4. CARE AND CLEANING
4.1 Notes on cleaning
Cleaning
Agents
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water
and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains ap‐
pliance must be cooled down and dried with clean cloth or paper tow‐
els.
Clean stains with a mild detergent.
Keep the hood
clean
Clean the appliance and grease filters each month. Clean the interior
and grease filters carefully from fat. Fat accumulation or other residue
may cause fire.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle.
The grease filter may discolour, it has no influence on the performance
of the appliance.
Charcoal filter
The time of saturation of the charcoal filter varies depending on the
type of cooking and the regularity of cleaning the grease filter.
4.2 Cleaning mode
Cleaning mode blocks the functionality of
control panel for 5 minutes. When active,
touching symbols has no effect.
Hob2Hood function is
disabled when cleaning
mode is active.
1. To activate the mode touch and hold
and for 1 second.
and turns on.
2. To deactivate the mode touch and
hold the symbols again for 1 second.
and turns off.
4.3 Cleaning the grease filter
Filters are mounted with the use of clips
and pins on the opposite side.
To clean the filter:
1. Pull the handle on the filter
underneath the hood (1) and slightly
tilt the front of the filter down.
ENGLISH 5

1
2. Clean the filters using a sponge with
non abrasive detergents or in a
dishwasher.
The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
3. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if
applicable.
4.4 Replacing the charcoal
filter - optional
WARNING!
Depending on type, filter can
be or cannot be
regenerated. Refer to the
leaflet provided with the
filter.
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Press the handle of the mounting clip
on the filter panel underneath the
hood (1).
1
2
3. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
4. To install a new filter, perform the
same steps in reverse order.
In any case, it is necessary to replace
the filters at least every four months.
4.5 Replacing the lamp
This appliance is supplied with a LED
lamp and separate control gear (LED
driver). These parts can be replaced by a
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
5. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
5.1 What to do if...
Problem Possible cause Remedy
You cannot activate the ap‐
pliance.
The appliance is not connec‐
ted to a power supply or it is
connected incorrectly.
Check if the appliance is cor‐
rectly connected to the elec‐
trical supply.
www.aeg.com6

Problem Possible cause Remedy
You cannot activate the ap‐
pliance.
The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
You cannot activate the ap‐
pliance.
Cabinet doors are not
aligned with the cabinet
frame.
Align the cabinet doors.
You cannot activate the ap‐
pliance.
The glass panel is not fully
opened.
Fully open the glass panel.
Refer to daily use chapter.
You cannot activate the ap‐
pliance or functions.
Incorrect usage of control
panel.
Touch the symbols on the
control panel directly in the
middle for at least 1 second
to activate appliance or func‐
tion.
The lamp does not operate. The lamp is defective. Replace the lamp. Refer to
the "Care and Cleaning"
chapter.
The appliance does not ab‐
sorb enough vapours.
The motor speed is not ade‐
quate to the appearing va‐
pours.
Change the speed of the
motor.
The appliance activate itself
or change function itself
There is a big condensation
of vapour on the glass.
Clean the glass from the wa‐
ter, ventilate the kitchen and
increase the speed of the
hood.
The filter alarm indicator
is on.
The filter alarm is on. The
grease filter must be cleaned
or the charcoal filter (option‐
al) must be replaced or
cleaned.
Refer to the filter notification
in "Daily use" chapter.
6. ENVIRONMENTAL CONCERNS
Recycle materials with the symbol .
Put the packaging in relevant containers
to recycle it. Help protect the
environment and human health by
recycling waste of electrical and
electronic appliances. Do not dispose of
appliances marked with the symbol
with the household waste. Return the
product to your local recycling facility or
contact your municipal office.
*
ENGLISH 7

www.aeg.com/shop
867351752-B-242022