
6IVEDPY 1110 - 4879010_01
IMPORTANT INFORMATION AND MAINTENANCE
WARNING: The fan coil is
connected to the power supply and a
water circuit. Operations performed
by persons without the required
technical skills can lead to personal
injury to the operator or damage to
the unit and surrounding objects.
ONLY POWER THE FAN COIL
AT 230V ~ 50Hz
Use of other power supplies could cause
permanent damage to the fan coil.
DO NOT USE THE FAN COIL
IMPROPERLY
Do not use the fan coil in animal
husbandry applications (e.g.
incubation).
AIRING THE ROOM
Periodically air the room in which the
fan coil has been installed; this is
particularly important if the room is
occupied by many people, or if gas
appliances or sources of odours are
present.
CORRECTLY REGULATING
THE TEMPERATURE
The external temperature should be
adjusted in order to provide maximum
comfort to the people in the room,
especially if they are elderly, children
or sick people; avoid differences over
7°C between the outdoor temperature
and the temperature inside the room in
summer.
In summer, a temperature that is too low
causes higher electrical consumption.
CORRECTLY ADJUSTING THE AIR JET
The area coming out of the fan coil
must not strike people directly; in fact,
even if at a temperature that is higher
than the room temperature, it could
cause a cold sensation and resulting
discomfort.
DO NOT USE EXCESSIVELY HOT WATER
Clean the fan coil with a soft cloth
or sponge soaked in water not over
40°C. Do not use chemical products
or solvents to clean any part of the
fancoil. Do not spray water on the
outer or inner surfaces of the fan coil (it
might cause short circuits).
CLEANING PERIODICALLY THE FILTER
Frequent cleaning of the filter will ensure
more efficient unit operation.
Check whether the filter is very dirty: in
this case, repeat the operation more
often.
Clean frequently. Remove the accumulated
dust with a vacuum cleaner.
When the filter is clean, refit it on the
fan coil following the dismantling
instructions in reverse order.
EXTRAORDINARY CLEANING
The fact that the blades of examinable
shrouds can be removed (operation done
only by adequately skilled technicians)
ensures a thorough cleaning of the
internal components, which is particularly
important when installing the unit in
crowded areas or venues requiring high
hygiene standards.
DURING OPERATIONS
Always leave the filter on the fan coil during
operation (otherwise dust in the air could
soil the coil surface area).
WHAT IS NORMAL
In the cooling operation, water vapour may
be present in the air delivery of the fan coil.
In the heating operation, a slight hiss
might be heard close to the fan coil.
Sometimes the fan coil might give
off unpleasant smells due to the
accumulation of substances present
in the air of the room (clean the filter
more often, especially if the room is
not ventilated regularly).
While the unit is functioning, there
could be noises and creaks inside
the device due to the various thermal
expansions of the elements (plastic and
metal), but this does not indicate any
malfunction and does not damage the
unit unless the maximum input water
temperature is exceeded.
MALFUNCTIONING
In the case of malfunctioning remove
the power to the unit then repower it
and start the apparatus up again.
CAUTION! Do not attempt to
repair the unit alone, this is extremely
dangerous!
If the problem occurs again, call your
areas After-Sales Service promptly.
DO NOT TUG THE ELECTRICAL CABLE
It is very dangerous to pull, tread on or
crush the electrical power cable or fix
it with nails or drawing pins.
A damaged power cable can cause short
circuits and personal injury.
DO NOT PUT ANYTHING IN THE AIR
OUTLETS
Never insert objects of any kind in the
air delivery and outlet.
This could cause injury to people
and damage to the fan.
CAUTION
Avoid any use of the device by children
or incompetent persons without
appropriate supervision; also note that
the unit should not be used by children
as a toy.
AIR FILTER REMOVAL AND
REPLACEMENT
The air filter must be removed from the
fan coil for cleaning.
The cleaned or new air filter (for
replacement) must be correctly fitted
and secured in its housing in the
fancoil.
To remove the air filter:
- loosen the screws of the two filter clips
- slide the two filter retainers until they
stop
- remove the filter from its housing
To reassemble the air filter:
- insert the air filter into its housing,
- slide the two filter clips until the filter
is secured,
- tighten the screws of the two filter clips,
- make sure the filter is secured in its
housing.
Consult control panel manual for installation and use instructions.
USE
The cassette fan coils are sent in standard packaging made of foam polystyrene and cardboard.
PACKAGING