AFI Branding ReFrame ILS140 User manual

www.afibranding.com.au | 1300 652 514 |33 Lakewood Blvd, Carrum Downs, Vic, 3201
Corner Brackets
ReFrame® Lengths
Allen Key
8x
4x
ReFrame® Power
Adapter
1x
1x
1
CHECKLIST
1
ILS140 - illuminated double-sided ReFrame®
assembly instructions
Lay out the ReFrame®
components on a flat
surface and ensure you have
everything required before
you start the assembly.
Slide top and side length together
Ensure the LED lighting strip ‘Male’ and external ‘Female’
plugs are on the same corner so they will reach when
the frames are connected.
2
5
Insert corner brackets into the tracks of the top and
bottom lengths of the frame
(Note: do not tighten any of the screws until step 8)
Female
3
4Repeat step 3 across all corners of frame
Male

ILS140 - illuminated double-sided ReFrame®
assembly instructions
www.afibranding.com.au | 1300 652 514 |33 Lakewood Blvd, Carrum Downs, Vic, 3201
Applying your custom ReFrame® fabric skin
11
Developed by AFI Branding
Now that you’ve finished assembling your ReFrame®, it’s time to apply your custom ReFrame® fabric skin. Please refer to
either a printed ‘ReFrame® Fabric Installation Guide’ or go to www.reframe.com.au to watch one of our instructional
assembly videos to see how to correctly apply your ReFrame® fabric skin.
NOTE: The assembly instructions for the ILS140 (and included components) illustrate the fundamental steps to assemble a
‘standard’ Illuminated Double-Sided type ReFrame®. If your Reframe® is oversize, has additional components such as joiners
(not shown on this fact sheet), accessories, or has bends/curves and you are unsure how to proceed with assembly, please
contact the team at AFI Branding on 1300 652 514 and we will guide you through the assembly process.
Repeat on the opposite corner so that 3 lengths are
connected
Ensure corners are aligned and then tighten screws using allen key (repeat this process on all corners)
Connect the LED lighting strip ‘Male’ plug and external
‘Female’ plug
Connect the ReFrame® Power Adapter to the external
cable
Attach the remaining two corners at the same time
6
8
9 10
7